A new approach and model for accurate determination of the dynamic pull-in parameters of microbeams actuated by a step voltage

Accurate determination of pull-in voltage and pull-in position is crucial in the design of electrostatically actuated microbeam-based devices. In the past, there have been many works on analytical modeling of the static pull-in of microbeams. However, unlike the static pull-in of microbeams where the analytical models have been well established, there are few works on analytical modeling of the dynamic pull-in of microbeam actuated by a step voltage. This paper presents two analytical approximate models for calculating the dynamic pull-in voltage and pull-in position of a cantilever beam and a clamped–clamped beam, respectively. The effects of the fringing field are included in the two models. The two models are derived based on the energy balance method. An N-order algebraic equation for the dynamic pull-in position is derived. An approximate solution of the N-order algebraic equation yields the dynamic pull-in position and voltage. The accuracy of the present models is verified by comparing their results with the experimental results and the published models available in the literature.

[1]  S. Krylov,et al.  Pull-in Dynamics of an Elastic Beam Actuated by Continuously Distributed Electrostatic Force , 2004 .

[2]  Stefano Lenci,et al.  Control of pull-in dynamics in a nonlinear thermoelastic electrically actuated microbeam , 2006 .

[3]  M. Younis,et al.  An Experimental and Theoretical Investigation of Dynamic Pull-In in MEMS Resonators Actuated Electrostatically , 2010, Journal of Microelectromechanical Systems.

[4]  Ali H. Nayfeh,et al.  Dynamic pull-in phenomenon in MEMS resonators , 2007 .

[5]  G. Barbastathis,et al.  Dynamic pull-in of parallel-plate and torsional electrostatic MEMS actuators , 2005, Journal of Microelectromechanical Systems.

[6]  S. Senturia,et al.  M-TEST: A test chip for MEMS material property measurement using electrostatically actuated test structures , 1997 .

[7]  J. Fluitman,et al.  Electrostatic curved electrode actuators , 1995 .

[8]  M. Ahmadian,et al.  Dynamic pull-in instability of electrostatically actuated beams incorporating Casimir and van der Waals forces , 2010 .

[9]  D. Elata,et al.  On the dynamic pull-in of electrostatic actuators with multiple degrees of freedom and multiple voltage sources , 2006, Journal of Microelectromechanical Systems.

[10]  Liying Jiang,et al.  Dynamic characteristics of a dielectric elastomer-based microbeam resonator with small vibration amplitude , 2011 .

[11]  J. Casals-Terre,et al.  Resonant Pull-In Condition in Parallel-Plate Electrostatic Actuators , 2007, Journal of Microelectromechanical Systems.

[12]  Alan Mathewson,et al.  Analysis of electromechanical boundary effects on the pull-in of micromachined fixed–fixed beams , 2003 .

[13]  Paul C.-P. Chao,et al.  DC dynamic pull-in predictions for a generalized clamped–clamped micro-beam based on a continuous model and bifurcation analysis , 2008 .

[14]  W. Miller,et al.  A closed-form model for the pull-in voltage of electrostatically actuated cantilever beams , 2005 .

[15]  D. N. Pawaskar,et al.  Closed-form empirical relations to predict the dynamic pull-in parameters of electrostatically actuated tapered microcantilevers , 2011 .

[16]  Robert Puers,et al.  Pull-in voltage analysis of electrostatically actuated beam structures with fixed–fixed and fixed–free end conditions , 2002 .

[17]  Amir Khajepour,et al.  Modeling of two-hot-arm horizontal thermal actuator , 2003 .

[18]  G. Rezazadeh,et al.  Application of the Generalized Differential Quadrature Method to the Study of Pull-In Phenomena of MEMS Switches , 2007, Journal of Microelectromechanical Systems.

[19]  S.K. De,et al.  Full-Lagrangian schemes for dynamic analysis of electrostatic MEMS , 2004, Journal of Microelectromechanical Systems.

[20]  Yuh-Chung Hu,et al.  Closed form solutions for the pull-in voltage of micro curled beams subjected to electrostatic loads , 2006 .

[21]  Ali H. Nayfeh,et al.  Dynamics of MEMS resonators under superharmonic and subharmonic excitations , 2005 .

[22]  Jin Cheng,et al.  Analytical and finite element model pull-in study of rigid and deformable electrostatic microactuators , 2004 .

[23]  M. Ahmadi,et al.  Pull-in voltage study of electrostatically actuated fixed-fixed beams using a VLSI on-chip interconnect capacitance model , 2006, Journal of Microelectromechanical Systems.

[24]  Fadi M. Alsaleem,et al.  On the nonlinear resonances and dynamic pull-in of electrostatically actuated resonators , 2009 .

[25]  N. Aluru,et al.  Complex nonlinear oscillations in electrostatically actuated microstructures , 2006, Journal of Microelectromechanical Systems.

[26]  G. K. Ananthasuresh,et al.  PULL-IN DYNAMICS OF ELECTROSTATICALLY-ACTUATED BEAMS , 1996 .