Design and experimental implementation of time delay control for air supply in a polymer electrolyte membrane fuel cell system

Abstract This paper studies the air flow control for preventing the starvation and/or obtaining the maximum net power of a Polymer Electrolyte Membrane (PEM) fuel cell system using time delay control (TDC). Feedforward and feedback controls are utilized simultaneously to prevent air shortage during the transient response of the fuel cell operation. The TDC algorithm design is created with a low-order dynamic model, and its superior performances are proven using a real-time control experiment. The optimal air excess ratio is calculated experimentally given the variation of the external load, and the net power increase is discussed by comparison with the results obtained from fixed air excess ratio. The Ballard 1.2 kW PEM fuel cell system is used for the experiments as a test rig, and the LabView system is used for the real-time air flow control. The superiority of the TDC performance is proven by comparison with other control algorithms such as the proportional–integral control (PIC), feedforward control, and the original manufacturer's control. The proposed control algorithm can improve PEM fuel cell system performance by preventing air shortage and/or by obtaining higher performance.

[1]  Kamal Youcef-Toumi,et al.  Application of decentralized time-delay controller to robot manipulators , 1989, Proceedings, 1989 International Conference on Robotics and Automation.

[2]  Andras Varga.  Numerical awareness in control , 2004 .

[3]  Young-Bae Kim,et al.  Study on the effect of humidity and stoichiometry on the water saturation of PEM fuel cells , 2012 .

[4]  Minggao Ouyang,et al.  Modeling and control of air stream and hydrogen flow with recirculation in a PEM fuel cell system - II. Linear and adaptive nonlinear control , 2006 .

[5]  Z. H. Wang,et al.  Two-phase flow and transport in the air cathode of proton exchange membrane fuel cells , 2000 .

[6]  Abdelkader Chaker,et al.  FUZZY LOGIC CONTROL OF FUEL CELL SYSTEM FOR RESIDENTIAL POWER GENERATION , 2009 .

[7]  K. Youcef-Toumi,et al.  Analysis of Linear Time Invariant Systems with Time Delay , 1992, 1992 American Control Conference.

[8]  A.G. Stefanopoulou,et al.  Control of fuel cell breathing , 2004, IEEE Control Systems.

[9]  Carlos Bordons,et al.  Real-Time Implementation of a Constrained MPC for Efficient Airflow Control in a PEM Fuel Cell , 2010, IEEE Transactions on Industrial Electronics.

[10]  Anna G. Stefanopoulou,et al.  Water equilibria and management using a two-volume model of a polymer electrolyte fuel cell , 2007 .

[11]  C. Bordons,et al.  Development and experimental validation of a PEM fuel cell dynamic model , 2007 .

[12]  Zhigang Shao,et al.  The effect of air stoichiometry change on the dynamic behavior of a proton exchange membrane fuel cell , 2008 .

[13]  S. Dutta,et al.  Numerical prediction of mass-exchange between cathode and anode channels in a PEM fuel cell , 2001 .

[14]  Haralambos Sarimveis,et al.  Operational optimization and real-time control of fuel-cell systems , 2009 .

[15]  Carlos Bordons,et al.  Design and experimental validation of a constrained MPC for the air feed of a fuel cell , 2009 .

[16]  D. Candusso,et al.  A review on polymer electrolyte membrane fuel cell catalyst degradation and starvation issues: Causes, consequences and diagnostic for mitigation , 2009 .

[17]  Young-Bae Kim,et al.  Improving dynamic performance of proton-exchange membrane fuel cell system using time delay control , 2010 .

[18]  Anna G. Stefanopoulou,et al.  Parameterization and prediction of temporal fuel cell voltage behavior during flooding and drying conditions , 2008 .

[19]  B. Gou,et al.  Feedback-Linearization-Based Nonlinear Control for PEM Fuel Cells , 2008, IEEE Transactions on Energy Conversion.

[20]  Yong-Song Chen.  A segmented model for studying water transport in a PEM fuel cell , 2009 .

[21]  Stefano Cordiner,et al.  3D effects of water-saturation distribution on polymeric electrolyte fuel cell (PEFC) performance , 2011 .

[22]  Chao-Yang Wang,et al.  Model of Two-Phase Flow and Flooding Dynamics in Polymer Electrolyte Fuel Cells , 2005 .

[23]  Y. B. Kim,et al.  Time delay control for fuel cells with bidirectional DC/DC converter and battery , 2010 .

[24]  Huei Peng,et al.  Model predictive control for starvation prevention in a hybrid fuel cell system , 2004, Proceedings of the 2004 American Control Conference.

[25]  Jong-Woo Ahn,et al.  Coolant controls of a PEM fuel cell system , 2008 .

[26]  A. Vahidi,et al.  A review of the main parameters influencing long-term performance and durability of PEM fuel cells , 2008 .

[27]  Zhixiang Liu,et al.  Behavior of PEMFC in starvation , 2006 .

[28]  Fu-Cheng Wang,et al.  An application of indirect model reference adaptive control to a low-power proton exchange membrane fuel cell , 2008 .

[29]  Anna G. Stefanopoulou,et al.  Control-Oriented Modeling and Analysis for Automotive Fuel Cell Systems , 2004 .

[30]  B. Diong,et al.  An improved small-signal model of the dynamic behavior of PEM fuel cells , 2003, IEEE Transactions on Industry Applications.

[31]  Michael A. Danzer,et al.  Prevention of fuel cell starvation by model predictive control of pressure, excess ratio, and current , 2009 .

[32]  Fu-Cheng Wang,et al.  Multivariable robust control of a proton exchange membrane fuel cell system , 2008 .

[33]  Pyung-Hun Chang,et al.  Stability Analysis of Discrete Time Delay Control for Nonlinear Systems , 2007, 2007 American Control Conference.