Criteria for crack initiation during rubber abrasion

The crack initiation process during blade abrasion of a rubber surface has been investigated both experimentally and using a FEA simulation. At first the crack initiates at the location of the maximum tensile stress, yielding a crack growth angle of between 30° and 50° with the rubber surface, with the angle increasing with the normal load applied on the blade. The crack growth angle reduces as the initial crack propagates. It passes through several steps, each with a reduced crack growth angle and eventually reaches a much smaller angle generally observed at the steady state of abrasion. This initial crack growth process is predicted well by the FEA simulation. Both the experimental and the calculated results suggest that the initial cracks in rubber abrasion originate from micro-vibrations generated during the slip stage of stick-slip motion, which arises during the frictional contact between a soft rubber and hard abrader.

[1]  Yoshihide Fukahori,et al.  Mechanism of rubber abrasion: Part 2. General rule in abrasion pattern formation in rubber-like materials , 1994 .

[2]  David Nowell,et al.  On the mechanics of fretting fatigue , 1988 .

[3]  Michel Barquins,et al.  Friction and wear of rubber-like materials , 1993 .

[4]  Alan N. Gent,et al.  Mechanisms of rubber abrasion , 1983 .

[5]  Christian Menger,et al.  Initiation and development of wear of an elastomeric surface by a blade abrader , 1999 .

[6]  A. Thomas,et al.  Studies of Rubber Abrasion , 1979 .

[7]  J. Busfield,et al.  Prediction of fatigue crack growth using finite element analysis techniques applied to three-dimensional elastomeric components , 2005 .

[8]  S. W. Zhang.  Investigation of Abrasion of Nitrile Rubber , 1984 .

[9]  M. C. Dubourg,et al.  A theoretical model for the prediction of initial growth angles and sites of fretting fatigue cracks , 1997 .

[10]  A. Schallamach,et al.  Abrasion of rubber by a needle , 1952 .

[11]  Staffan Söderberg,et al.  Contact conditions and surface degradation mechanisms in low amplitude fretting , 1988 .

[12]  Yoshihide Fukahori,et al.  Mechanism of rubber abrasion part 3: how is friction linked to fracture in rubber abrasion? , 1995 .

[13]  M. Barquins,et al.  Rubber friction and the rheology of viscoelastic contact , 1975 .

[14]  Lieng-Huang Lee,et al.  Advances in Polymer Friction and Wear , 1975 .

[15]  J. Padovan,et al.  Simulation of Surface Flaw Propagation Associated with the Mechanical Fatigue Wear of Elastomers , 1998 .

[16]  Y. Fukahori,et al.  Stress analysis of elastomeric materials at large extensions using the finite element method , 1993, Journal of Materials Science.

[17]  Yoshihide Fukahori,et al.  Mechanism of rubber abrasion. Part I: Abrasion pattern formation in natural rubber vulcanizate , 1994 .

[18]  A. Schallamach.  How Does Rubber Slide , 1971 .