Environmental impacts of electricity production of micro wind turbines with vertical axis

The increasing focus on the installation of sustainable energy systems has resulted in a wide range of micro wind turbine systems being introduced in the market. Although the majority of the commercially installed wind turbines are the horizontal axis ones, vertical axis turbines are considered as a promising technology for the future. It is generally known that the environmental impacts generated in the operational stage of wind turbines are significantly lower than the ones, generated by the fossil fuels based systems. The use of the Life Cycle Assessment (LCA) enables to assess the environmental impacts of a product or a process, taking into consideration also raw material extraction, manufacturing, distribution, and disposal stages of life cycle. The contribution of these stages is often critical for the environmental impacts of the bioenergy systems. This study contributes to the existing knowledge by presenting the detailed LCA of electricity produced in micro wind turbines with the vertical axis. For the impact assessment, two methods were selected: the CML-IA and Thermo-Ecological Cost in the whole life cycle (TEC-LC). Firstly, the environmental impacts of electricity generated by wind turbines with 1 and 3 kW nominal power were evaluated and compared with each other and with the impacts of the grid electricity produced in the Italian energy mix. Next, the sensitivity of the impact results on the wind characteristics variability was investigated. Results showed that the 3 kW turbine has, in general, lower values of the environmental impact indicators per unit of produced energy than the 1 kW turbine from 27% lower Global Warming Potential (GWP) to 75% lower Abiotic Depletion (ADP). The impacts per unit of produced energy in the analysed micro wind turbines are lower than the corresponding impacts for the grid electricity generated in the Italian energy mix for nine impact indicators out of twelve. It was also observed that wind distribution parameters strongly influence the environmental impacts of the electricity produced by the considered turbines, leading to values higher than those obtained for Italian energy mix for low wind average speed and, even more, for low variances of the average wind speed.

[1]  J. Munksgaard,et al.  Energy and CO2 life-cycle analyses of wind turbines—review and applications , 2002 .

[2]  L. A. Danao,et al.  An Experimental Investigation into the Influence of Unsteady Wind on the Performance of a Vertical Axis Wind Turbine , 2013 .

[3]  Edgar G. Hertwich,et al.  Critical Review: Life-Cycle Inventory Procedures for Long-Term Release of Metals , 2008 .

[4]  J. Szargut.  Exergy Method: Technical and Ecological Applications , 2005 .

[5]  Wiesław Gazda,et al.  Thermo-ecological assessment of CCHP (combined cold-heat-and-power) plant supported with renewable energy , 2015 .

[6]  Eric Johnson.  Handbook on Life Cycle Assessment Operational Guide to the ISO Standards , 2003 .

[7]  Abdollah A. Afjeh,et al.  Wind energy: Trends and enabling technologies , 2016 .

[8]  Saad Mekhilef,et al.  Progress and recent trends of wind energy technology , 2013 .

[9]  Jessica Lohmann,et al.  Life cycle assessment of the offshore wind farm alpha ventus , 2011 .

[10]  Brian A. Fleck,et al.  Comparative life-cycle assessment of a small wind turbine for residential off-grid use , 2009 .

[11]  Mazharul Islam,et al.  Aerodynamic models for Darrieus-type straight-bladed vertical axis wind turbines , 2008 .

[12]  Begoña Guezuraga,et al.  Life cycle assessment of two different 2 MW class wind turbines , 2012 .

[13]  Wojciech Stanek,et al.  Depletion of the non-renewable natural exergy resources as a measure of the ecological cost , 2002 .

[14]  Abhishiktha Tummala,et al.  A review on small scale wind turbines , 2016 .

[15]  Stefano Pellegrini,et al.  Life-cycle assessment of a 2-MW rated power wind turbine: CML method , 2008 .

[16]  Barbara Mendecka,et al.  Probabilistic multi-criteria analysis for evaluation of biodiesel production technologies from used cooking oil , 2017 .

[17]  Mats Leijon,et al.  Evaluation of different turbine concepts for wind power , 2008 .

[18]  Massachusetts Clean Water Trust..  2015 Annual Report , 2015 .

[19]  N. Jenkins,et al.  Wind Energy Handbook: Burton/Wind Energy Handbook , 2011 .

[20]  Wiesław Gazda,et al.  Exergo-ecological evaluation of adsorption chiller system , 2014 .

[21]  Robert H. Crawford,et al.  Life cycle energy and greenhouse emissions analysis of wind turbines and the effect of size on energy yield , 2009 .

[22]  S. Pellegrini,et al.  Life cycle assessment of a multi-megawatt wind turbine , 2009 .

[23]  W. R. Hargraves,et al.  Nationwide assessment of potential output from wind-powered generators , 1976 .

[24]  Yuxuan Wang,et al.  Life cycle assessment of CO2 emissions from wind power plants: Methodology and case studies , 2012 .

[25]  Wojciech Stanek,et al.  Environmental Quality Evaluation of Hard Coal Using Lca and Exergo-ecological Cost Methodology , 2014 .

[26]  Wojciech Stanek,et al.  Thermo-ecological optimization of a solar collector , 2007 .

[27]  Lidia Lombardi,et al.  Comparative life cycle assessment of alternative strategies for energy recovery from used cooking oil. , 2017, Journal of environmental management.

[28]  T. Maeda,et al.  A straight-bladed vertical axis wind turbine with a directed guide vane row — Effect of guide vane geometry on the performance — , 2009 .

[29]  Bing Xue,et al.  A life cycle co-benefits assessment of wind power in China , 2015 .

[30]  S. Y. Liang,et al.  Design and Test of a Vertical-Axis Wind Turbine with Pitch Control , 2012 .

[31]  Julia C. Chatterton,et al.  Carbon Brainprint Case Study: novel offshore vertical axis wind turbines , 2011 .

[32]  R. Kleijn,et al.  Life cycle inventory of the production of rare earths and the subsequent production of NdFeB rare earth permanent magnets. , 2014, Environmental science & technology.

[33]  Sunil Puri.  RE policy in India , 2003 .

[34]  E. Martínez,et al.  Comparative evaluation of life cycle impact assessment software tools through a wind turbine case study , 2015 .

[35]  Pei-Te Chiueh,et al.  Life cycle assessment and net energy analysis of offshore wind power systems , 2017 .

[36]  Karl R. Haapala,et al.  Comparative life cycle assessment of 2.0 MW wind turbines , 2014 .

[37]  T. Nemecek,et al.  Overview and methodology: Data quality guideline for the ecoinvent database version 3 , 2013 .

[38]  Wojciech Stanek,et al.  Thermo-ecological cost of hard coal with inclusion of the whole life cycle chain , 2015 .

[39]  L. Lombardi,et al.  Environmental assessment of wind turbine systems based on thermo-ecological cost , 2016, Energy.

[40]  Brian A. Fleck,et al.  Comparative life cycle energy, emission, and economic analysis of 100 kW nameplate wind power generation , 2012 .

[41]  Wojciech Stanek,et al.  Thermodynamic evaluation of biomass-to-biofuels production systems. , 2013 .

[42]  Edgar G. Hertwich,et al.  Life cycle assessment of a floating offshore wind turbine , 2009 .

[43]  Md. Shazib Uddin,et al.  Energy, emissions and environmental impact analysis of wind turbine using life cycle assessment technique , 2014 .

[44]  Roberto Dones,et al.  Life Cycle Inventories of Energy Systems: Results for Current Systems in Switzerland and other UCTE Countries , 2007 .

[45]  David Greenblatt,et al.  Vertical axis wind turbine performance enhancement using plasma actuators , 2012 .

[46]  Philip G. Hill,et al.  Power generation , 1927, Journal of the A.I.E.E..

[47]  Francis Meunier,et al.  Life cycle analysis of 4.5 MW and 250 W wind turbines , 2009 .

[48]  Valerio Lo Brano,et al.  Energy performances and life cycle assessment of an Italian wind farm , 2008 .

[49]  Zbigniew Bulinski,et al.  Numerical modeling and preliminary validation of drag-based vertical axis wind turbine , 2015 .

[50]  Fabrizio Cumo,et al.  A preliminary energy and environmental assessment of a micro wind turbine prototype in natural protected areas , 2014 .

[51]  Martin Kaltschmitt,et al.  Greenhouse gas emissions from electricity generated by offshore wind farms , 2014 .

[52]  Edgar G. Hertwich,et al.  Assessing the life cycle environmental impacts of wind power: A review of present knowledge and research needs , 2012 .

[53]  Jorge Islas,et al.  Life cycle assessment: A case study of two wind turbines used in Mexico , 2015 .

[54]  Bin Song,et al.  LCAs of a polycrystalline photovoltaic module and a wind turbine , 2011 .

[55]  S. Tullis,et al.  Flow separation on a high Reynolds number, high solidity vertical axis wind turbine with straight and canted blades and canted blades with fences , 2012 .

[56]  Adisa Azapagic,et al.  Environmental impacts of micro-wind turbines and their potential to contribute to UK climate change targets , 2013 .

[57]  Wiesław Gazda,et al.  Thermoecological cost of electricity, heat and cold generated in a trigeneration module fuelled with selected fossil and renewable fuels , 2015 .

[58]  Samir Ziada,et al.  Measurement of high solidity vertical axis wind turbine aerodynamic loads under high vibration response conditions , 2012 .

[59]  Ning Qin,et al.  Wind tunnel and numerical study of a small vertical axis wind turbine , 2008 .

[60]  R. C. Maydew,et al.  Aerodynamic performance of vertical and horizontal axis wind turbines , 1981 .

[61]  Jacqueline E. Tamis,et al.  A method for improving Centre for Environmental Studies (CML) characterisation factors for metal (eco)toxicity — the case of zinc gutters and downpipes , 2010 .

[62]  Liselotte Schleisner,et al.  Life cycle assessment of a wind farm and related externalities , 2000 .

[63]  Kari Larsen,et al.  Recycling wind turbine blades , 2009 .

[64]  Ole Jørgen Hanssen,et al.  Life cycle greenhouse gas (GHG) emissions from the generation of wind and hydro power , 2011 .