Fabrication of a high performance acoustic emission (AE) sensor to monitor and diagnose disturbances in HTS tapes and magnet systems

[1]  H. M. Kim,et al.  A stability verification technique using acoustic emission for an HTS monofilar component for a superconducting fault current limiter , 2007 .

[2]  Hyoun‐Ee Kim,et al.  Windmill-type ultrasonic micromotor fabricated by thermoplastic green machining process , 2007 .

[3]  Wook Jo,et al.  Abnormal Grain Growth of Lead Zirconium Titanate (PZT) Ceramics Induced by the Penetration Twin , 2006 .

[4]  Long Wu,et al.  Promotion of piezoelectric properties of lead zirconate titanate ceramics with (Zr,Ti) partially replaced by Nb2O5 , 2004 .

[5]  Y. Iwasa,et al.  Detection of 'hot spots' in HTS coils and test samples with acoustic emission signals , 2004, IEEE Transactions on Applied Superconductivity.

[6]  A. Ninomiya,et al.  Diagnosis of ITER's large scale superconducting coils using acoustic emission techniques , 2003 .

[7]  Z. Meng,et al.  Effect of Zr/Ti ratio on the properties of PMMN–PZT ceramics near the morphotropic phase boundary , 2003 .

[8]  S. Chu,et al.  Effects of sintering temperature on the dielectric and piezoelectric properties of Sr additive Sm-modified PbTiO3 ceramics , 2002 .

[9]  A. Bhalla,et al.  Low-temperature properties of lead nickel-niobate ceramics , 2002 .

[10]  W. Z. Zhu,et al.  Effect of Mn-doping on the morphotropic phase boundary of PZN-BT-PT system , 2001 .

[11]  Ki-Woo Nam,et al.  Fatigue crack propagation of super duplex stainless steel with dispersed structure and time-frequency analysis of acoustic emission , 2001 .

[12]  T. Saitoh,et al.  Acoustic emission occurrence induced from a NbTi superconducting coil under alternating current operation , 1999, IEEE Transactions on Applied Superconductivity.

[13]  D. C. Agrawal,et al.  Effect of net PbO content on mechanical and electromechanical properties of lead zirconate titanate ceramics , 1999 .

[14]  Y. Iwasa,et al.  Heating-Induced acoustic emission in an adiabatic high-temperature superconducting winding , 1997 .

[15]  Martin N. Wilson,et al.  Case studies in superconducting magnets: Yukikazu Iwasa , 1996 .

[16]  B. Mazurek,et al.  Acoustic emission from high Tc superconductors during current flow , 1993 .

[17]  S. Nishijima,et al.  Instability of superconducting racetrack magnets , 1991 .

[18]  K. Tsuchiya,et al.  Investigation of wire motion in superconducting magnets , 1990 .

[19]  Kazuo Funaki,et al.  Instabilities due to mechanical strain energy in superconducting magnets , 1987 .

[20]  Y. Iwasa,et al.  Acoustic emission monitoring results from a fermi dipole , 1986 .

[21]  Y. Iwasa,et al.  Experimental and theoretical investigation of mechanical disturbances in epoxy-impregnated superconducting coils. 3. Fracture-induced premature quenches , 1985 .

[22]  Y. Iwasa,et al.  Correlation of acoustic emission with normal zone occurrence in epoxy‐impregnated windings: An application of acoustic emission diagnostic technique to pulse superconducting magnets , 1984 .

[23]  Yukikazu Iwasa,et al.  Method to detect a temperature rise in superconducting coils with piezoelectric sensors , 1983 .

[24]  M. Pappe.  Discussion of acoustic emission of a superconducting solenoid , 1983 .

[25]  Y. Iwasa,et al.  Sources of acoustic emission in superconducting magnets , 1983 .

[26]  Y. Iwasa,et al.  Acoustic emission triangulation of disturbances and quenches in a superconductor and a superconducting magnet , 1982 .

[27]  Y. Iwasa,et al.  Identification of quench origins in a superconductor with acoustic emission and voltage measurements , 1981 .

[28]  K. Koyama,et al.  Acoustic emission from superconducting magnets , 1977 .

[29]  R. Griffiths,et al.  Calculations in ceramics , 1977 .

[30]  G. Pásztor,et al.  Superconductors under dynamic mechanical stress , 1977 .