Electrochemical drilling with vacuum extraction of electrolyte

Forward flow pattern of electrolyte is widely used in electrochemical drilling (ECD) process. But electrolyte in the machining gap presents a sharp divergent flow which causes an abnormal dissolution and even harmful sparking. Reverse flow of electrolyte leads to a stable machining process but is rarely used due to the poor application feasibility. In this paper, an electrochemical drilling method with vacuum extraction of electrolyte has been proposed. Vacuum extraction of electrolyte greatly facilitates the application of reverse flow in electrochemical drilling. Flow distributions along the machining gap with different electrolyte flow pattern are compared numerically and experimentally. Reverse flow using vacuum extraction is shown to improve the process stability while diminishing sparking and formation of striations. Machining characteristics of vacuum extraction are investigated experimentally. To minimize the radial overcut of machined hole by electrochemical machining with vacuum extraction of electrolyte, the orthogonal design is used to optimize process parameters such as initial machining gap, applied voltage, tool feed rate, and electrolyte concentration. Good results have been obtained in the experiments with optimized parameters.

[1]  John Atkinson,et al.  Shaped tube electrochemical drilling of good quality holes , 2009 .

[2]  Anjali V. Kulkarni,et al.  Hole quality and interelectrode gap dynamics during pulse current electrochemical deep hole drilling , 2007 .

[3]  M. S. Hewidy,et al.  Modelling the performance of ECM assisted by low frequency vibrations , 2007 .

[4]  D. Zhu,et al.  Improvement of electrochemical machining accuracy by using dual pole tool , 2002 .

[5]  Kamlakar P Rajurkar,et al.  New Developments in Electro-Chemical Machining , 1999 .

[6]  Kamlakar P Rajurkar,et al.  Electrochemical machining under orbital motion conditions , 2001 .

[7]  Mcgeough J.A,et al.  Recent Research and Developments in Electrochemical Machining , 2003 .

[8]  Mohan Sen,et al.  A review of electrochemical macro- to micro-hole drilling processes , 2005 .

[9]  B. Bhattacharyya,et al.  Experimental investigation into electrochemical micromachining (EMM) process , 2003 .

[10]  Kamlakar P Rajurkar,et al.  Improvement of Electrochemical Machining Accuracy by Using Orbital Electrode Movement , 1999 .

[11]  J. A. McGeough,et al.  Intelligent concurrent manufacturability evaluation of design for electrochemical machining , 1996 .

[12]  Zinovi Brusilovski.  Adjustment and readjustment of electrochemical machines and control of the process parameters in machining shaped surfaces , 2008 .

[13]  John Fay Wilson,et al.  Practice and theory of electrochemical machining , 1971 .

[14]  J. A. McGeough,et al.  Precision ECM by Process Characteristic Modelling , 2000 .

[15]  G. K. Lal,et al.  Stray current attack and stagnation zones in electrochemical drilling , 2005 .