Micro-packages based on alumina ceramics hermetically sealed with glass solder were fabricated and tested over a 1.5 years period under accelerated aging at 85 °C. A device for sealing the 1.2 mm high, and ø10mm packages while cooling the critical centre of the package containing the electronics was developed. Heating of the rim up to 550 °C while maintaining the package centre below 300°C was successful, allowing a symmetrical heating of the device during the sealing procedure. The fabricated packages with an inner volume of 0.05 cc were backfilled with helium and tested for hermeticity with a fine leak tester. Samples passing the fine leak (1·10-12 atm·cc/s) test were attached to a larger chamber containing a humidity sensor. Some devices covered in PDMS and some directly exposed were stored at 85 °C in water to measure the humidity intrusion into the device due to deterioration of glass solder. 1 out of the 8 successfully fabricated devices failed after 5 years extrapolated lifetime. Two of the devices have kept constant humidity levels while others gradually rise. Nevertheless, 7 out of 8 have maintained a level below 17000 ppm humidity. Furthermore, the deterioration of glass solder was electrically and optically studied over a year's period showing no corrosion of glass if properly coated in PDMS.
[1]
G. Suaning,et al.
Hermetic Encapsulation of an Implantable Vision Prosthesis – Combining Implant Fabrication Philosophies
,
2008
.
[2]
Thomas Stieglitz,et al.
Ensuring minimal humidity levels in hermetic implant housings
,
2011,
2011 Annual International Conference of the IEEE Engineering in Medicine and Biology Society.
[3]
Thomas Stieglitz,et al.
A device for vacuum drying, inert gas backfilling and solder sealing of hermetic implant packages
,
2010,
2010 Annual International Conference of the IEEE Engineering in Medicine and Biology.
[4]
Ronald Mai,et al.
The biomaterial influences the ossification after sinus floor elevation using tissue-engineered bone grafts
,
2008,
Biomedizinische Technik. Biomedical engineering.
[5]
Thomas Stieglitz,et al.
Fabrication and test of a hermetic miniature implant package with 360 electrical feedthroughs
,
2010,
2010 Annual International Conference of the IEEE Engineering in Medicine and Biology.