Thermal stability analysis of AlGaAs/GaAs heterojunction bipolar transistors with multiple emitter fingers

A numerical electro-thermal model was developed for AlGaAs/GaAs heterojunction bipolar transistors (HBT's) to describe the base current, current gain and output power dependence on junction temperature. The model is applied to microwave HBT devices with multi-emitter fingers. The calculated results of the common-emitter, current-voltage characteristics in the linear active region show a "current crush" effect due to inherent nonuniform junction temperature, current density and current gain distribution in the device. The formation of highly localized high temperature regions, i.e., hot spots, occur when the device is operating beyond the current-crush point. This thermally induced current instability imposes an upper limit on the power capability of HBT's. The dependence of this effect on various factors is discussed. These factors include the intrinsic parameters such as the base current ideality factor, the "apparent" valence band discontinuity, and the temperature coefficient of the emitter-base turn-on voltage, as well as the extrinsic factors such as the emitter contact specific resistance, the substrate thermal conductivity and the heat source layout. >

[1]  Temperature-dependent large signal model of heterojunction bipolar transistors , 1992, GaAs IC Symposium Technical Digest 1992.

[2]  N. Camilleri,et al.  AlGaAs/GaAs Heterojunction Bipolar Transistors For Power Applications , 1987, IEEE/Cornell Conference on Advanced Concepts in High Speed Semiconductor Devices and Circuits, 1987. Proceedings..

[3]  M. G. Adlerstein,et al.  Thermal resistance measurements for AlGaAs/GaAs heterojunction bipolar transistors , 1991 .

[4]  R. D. Hudgens,et al.  5 W monolithic HBT amplifier for broadband X-band applications , 1990, IEEE Symposium on Microwave and Millimeter-Wave Monolithic Circuits.

[5]  Hua Quen Tserng,et al.  2.5 W CW X-band heterojunction bipolar transistor , 1989, IEEE MTT-S International Microwave Symposium Digest.

[6]  Hadis Morkoç,et al.  Negative output differential resistance in AlGaAs/GaAs heterojunction bipolar transistors , 1992 .

[7]  J. L. Ebel,et al.  Thermal effects on the characteristics of AlGaAs/GaAs heterojunction bipolar transistors using two-dimensional numerical simulation , 1993 .

[8]  T. Kim,et al.  12 W monolithic X-band HBT power amplifier , 1992, IEEE 1992 Microwave and Millimeter-Wave Monolithic Circuits Symposium Digest of Papers.

[9]  P. D. Maycock,et al.  Thermal conductivity of silicon, germanium, III–V compounds and III–V alloys , 1967 .

[10]  B. Bayraktaroglu,et al.  Monolithic X-band heterojunction bipolar transistor power amplifiers , 1989, 11th Annual Gallium Arsenide Integrated Circuit (GaAs IC) Symposium.

[11]  Electrical and thermal characteristics of heterojunction bipolar transistors fabricated on peeled film epitaxial layers , 1991, [1991] Proceedings IEEE/Cornell Conference on Advanced Concepts in High Speed Semiconductor Devices and Circuits.

[12]  Numerical studies of thermal effects on heterojunction bipolar transistor current-voltage characteristics using one-dimensional simulation , 1992 .

[13]  H. Morkoç,et al.  Thermal design studies of high-power heterojunction bipolar transistors , 1989 .

[14]  James S. Harris,et al.  Diode ideality factor for surface recombination current in AlGaAs/GaAs heterojunction bipolar transistors , 1992 .

[15]  R. H. Winkler.  Thermal properties of high-power transistors , 1967 .

[16]  Peter M. Asbeck,et al.  Determination of junction temperature in AlGaAs/GaAs heterojunction bipolar transistors by electrical measurement , 1992 .

[17]  W. B. Joyce,et al.  Thermal resistance of heat sinks with temperature-dependent conductivity , 1975 .

[18]  E. Johnson.  Physical limitations on frequency and power parameters of transistors , 1965 .