Improving the wind environment in high-density cities by understanding urban morphology and surface roughness: A study in Hong Kong

Abstract In this study, a high-resolution frontal area density (FAD) map that depicts the surface roughness of urban Hong Kong is produced using a mapping method that takes into account the dense urban morphology and the site wind availability of the territory. Using the MM5/CALMET model simulated wind data of Hong Kong, the FAD map of three urban zones are calculated: podium (0–15m), building (15–60m), and urban canopy (0–60m). The wind tunnel test data is used to correlate the FAD understanding of the three zones. The grid sensitivity test indicates that 200m×200m is the reasonable resolution for the FAD map; the test also establishes that the lower urban podium zone yields the best correlation with the experimental data. The study further establishes that the simpler two-dimensional ground coverage ratio (GCR), which is readily available in the planning circle, can be used to predict the area's average pedestrian level urban ventilation performance of the city. Working with their inhouse GIS team using available data, it allows the planners a way to understand the urban ventilation of the city for decisions related to air paths, urban permeability and site porosity.

[1]  Janet E. Nichol,et al.  A simple method for designation of urban ventilation corridors and its application to urban heat island analysis , 2010 .

[2]  C. Ratti,et al.  Analysis of 3-D Urban Databases with Respect to Pollution Dispersion for a Number of European and American Cities , 2001 .

[3]  Timothy R. Oke,et al.  Aerodynamic Properties of Urban Areas Derived from Analysis of Surface Form , 1999 .

[4]  J. Monteith,et al.  Boundary Layer Climates. , 1979 .

[5]  Ryozo Ooka,et al.  CFD analysis of mesoscale climate in the Greater Tokyo area , 1997 .

[6]  E. Ng.  Policies and technical guidelines for urban planning of high-density cities – air ventilation assessment (AVA) of Hong Kong , 2008, Building and Environment.

[7]  L. J. Purdue,et al.  Wind Tunnel Evaluation of PM10 Samplers , 1990 .

[8]  Jörg Franke,et al.  Recommendations of the COST action C14 on the use of CFD in predicting pedestrian wind environment , 2006 .

[9]  Dorothy Mackenzie,et al.  Design For The Environment , 1991 .

[10]  Hideyuki Tanaka,et al.  EXPERIMENTAL STUDY ON AIR VENTILATION IN A BUILT-UP AREA WITH CLOSELY-PACKED HIGH-RISE BUILDINGS , 2008 .

[11]  Ryozo Ooka,et al.  CFD analysis of wind climate from human scale to urban scale , 1999 .

[12]  C. Williams,et al.  Determination of the pedestrian wind environment in the city of Ottawa using wind tunnel and field measurements , 1992 .

[13]  M. Letzel,et al.  High resolution urban large-eddy simulation studies from street canyon to neighbourhood scale , 2008 .

[14]  A. Mochida,et al.  Wind tunnel tests on the relationship between building density and pedestrian-level wind velocity: Development of guidelines for realizing acceptable wind environment in residential neighborhoods , 2008 .

[15]  A. Arnfield.  Two decades of urban climate research: a review of turbulence, exchanges of energy and water, and the urban heat island , 2003 .

[16]  日本建築学会.  Architectural Institute of Japan , 1990 .

[17]  R. Griffiths,et al.  An improved method for the estimation of surface roughness of obstacle arrays , 1998 .

[18]  Alexis K.H. Lau,et al.  Developing a high-resolution wind map for a complex terrain with a coupled MM5/CALMET system , 2007 .

[19]  Alan G. Davenport,et al.  Estimating the roughness of cities and sheltered country , 2000 .

[20]  Yoshihide Tominaga,et al.  AIJ guidelines for practical applications of CFD to pedestrian wind environment around buildings , 2008 .

[21]  Alexis K.H. Lau,et al.  Air ventilation impacts of the "wall effect" resulting from the alignment of high-rise buildings , 2009 .

[22]  Y. Shao,et al.  A scheme for drag partition over rough surfaces , 2005 .

[23]  Yasunobu Ashie,et al.  Effects of sea breeze on thermal environment as a measure against Tokyo's urban heat island , 2009 .

[24]  Hiroaki Kondo,et al.  Numerical analysis of diffusion around a suspended expressway by a multi-scale CFD model , 2005 .

[25]  E. Plate.  Methods of investigating urban wind fields—physical models , 1999 .

[26]  M. Raupach.  Drag and drag partition on rough surfaces , 1992 .

[27]  J. Dudhia.  A Nonhydrostatic Version of the Penn State–NCAR Mesoscale Model: Validation Tests and Simulation of an Atlantic Cyclone and Cold Front , 1993 .

[28]  J. Unger,et al.  Detection of ventilation paths using high-resolution roughness parameter mapping in a large urban area , 2009 .

[29]  Marcel Bottema,et al.  Roughness parameters over regular rough surfaces: Experimental requirements and model validation , 1996 .

[30]  Mathias W. Rotach,et al.  A wind tunnel study of organised and turbulent air motions in urban street canyons , 2001 .

[31]  H. Lettau.  Note on Aerodynamic Roughness-Parameter Estimation on the Basis of Roughness-Element Description , 1969 .

[32]  H. Landsberg.  Urban Climate , 2011, Urban Ecology for Citizens and Planners.