Surface modification of droplet polymeric microfluidic devices for the stable and continuous generation of aqueous droplets.

Droplet microfluidics performed in poly(methyl methacrylate) (PMMA) microfluidic devices resulted in significant wall wetting by water droplets formed in a liquid-liquid segmented flow when using a hydrophobic carrier fluid such as perfluorotripropylamine (FC-3283). This wall wetting led to water droplets with nonuniform sizes that were often trapped on the wall surfaces, leading to unstable and poorly controlled liquid-liquid segmented flow. To circumvent this problem, we developed a two-step procedure to hydrophobically modify the surfaces of PMMA and other thermoplastic materials commonly used to make microfluidic devices. The surface-modification route involved the introduction of hydroxyl groups by oxygen plasma treatment of the polymer surface followed by a solution-phase reaction with heptadecafluoro-1,1,2,2-tetrahydrodecyl trichlorosilane dissolved in fluorocarbon solvent FC-3283. This procedure was found to be useful for the modification of PMMA and other thermoplastic surfaces, including polycyclic olefin copolymer (COC) and polycarbonate (PC). Angle-resolved X-ray photoelectron spectroscopy indicated that the fluorination of these polymers took place with high surface selectivity. This procedure was used to modify the surface of a PMMA droplet microfluidic device (DMFD) and was shown to be useful in reducing the wetting problem during the generation of aqueous droplets in a perfluorotripropylamine (FC-3283) carrier fluid and could generate stable segmented flows for hours of operation. In the case of PMMA DMFD, oxygen plasma treatment was carried out after the PMMA cover plate was thermally fusion bonded to the PMMA microfluidic chip. Because the appended chemistry to the channel wall created a hydrophobic surface, it will accommodate the use of other carrier fluids that are hydrophobic as well, such as hexadecane or mineral oils.

[1]  P. Alexandridis,et al.  Synthesis and Application of Fluorescein-Labeled Pluronic Block Copolymers to the Study of Polymer−Surface Interactions , 2001 .

[2]  M. Morra,et al.  Hydrophobic recovery and misting behavior of plasma treated PS and PC surfaces , 1991 .

[3]  Armand Ajdari,et al.  Droplet Control for Microfluidics , 2005, Science.

[4]  J. Koberstein,et al.  Preferential surface adsorption in miscible blends of polystyrene and poly(vinyl methyl ether) , 1988 .

[5]  G. Whitesides,et al.  Monolayers on disordered substrates: self-assembly of alkyltrichlorosilanes on surface-modified polyethylene and poly(dimethylsiloxane) , 1993 .

[6]  Helen Song,et al.  Controlling nonspecific protein adsorption in a plug-based microfluidic system by controlling interfacial chemistry using fluorous-phase surfactants. , 2005, Analytical chemistry.

[7]  Helen Song,et al.  Millisecond kinetics on a microfluidic chip using nanoliters of reagents. , 2003, Journal of the American Chemical Society.

[8]  D. Belder.  Microfluidics with droplets. , 2005, Angewandte Chemie.

[9]  Teodor Veres,et al.  Surface modification of thermoplastics--towards the plastic biochip for high throughput screening devices. , 2007, Lab on a chip.

[10]  Liang Li,et al.  Nanoliter microfluidic hybrid method for simultaneous screening and optimization validated with crystallization of membrane proteins , 2006, Proceedings of the National Academy of Sciences.

[11]  J. Badyal,et al.  Solventless coupling of perfluoroalkylchlorosilanes to atmospheric plasma activated polymer surfaces , 2005 .

[12]  David N. Adamson,et al.  Production of arrays of chemically distinct nanolitre plugs via repeated splitting in microfluidic devices. , 2006, Lab on a chip.

[13]  Steven A. Soper,et al.  Evaluation of micromilled metal mold masters for the replication of microchip electrophoresis devices , 2006 .

[14]  Robert F Shepherd,et al.  Microfluidic assembly of homogeneous and Janus colloid-filled hydrogel granules. , 2006, Langmuir : the ACS journal of surfaces and colloids.

[15]  D. Allara,et al.  Mean free path for inelastic scattering of 1.2 kev electrons in thin poly(methylmethacrylate) films , 1980 .

[16]  Steven A Soper,et al.  Photochemically patterned poly(methyl methacrylate) surfaces used in the fabrication of microanalytical devices. , 2005, The journal of physical chemistry. B.

[17]  G. Whitesides,et al.  Adsorption of proteins onto surfaces containing end-attached oligo(ethylene oxide): a model system using self-assembled monolayers , 1993 .

[18]  Minoru Seki,et al.  Hydrodynamic control of droplet division in bifurcating microchannel and its application to particle synthesis. , 2008, Journal of colloid and interface science.

[19]  G. Whitesides,et al.  Fabrication of microfluidic systems in poly(dimethylsiloxane) , 2000, Electrophoresis.

[20]  D. D. Dixon,et al.  A Technique for Imparting Soil-Release, Soil-Antiredeposition, and Moisture-Transport Properties to Polyester , 1977 .

[21]  Wei Li,et al.  Janus and ternary particles generated by microfluidic synthesis: design, synthesis, and self-assembly. , 2006, Journal of the American Chemical Society.

[22]  Joshua D. Tice,et al.  Microfluidic systems for chemical kinetics that rely on chaotic mixing in droplets , 2004, Philosophical Transactions of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[23]  Paul I. Okagbare,et al.  Highly efficient circulating tumor cell isolation from whole blood and label-free enumeration using polymer-based microfluidics with an integrated conductivity sensor. , 2008, Journal of the American Chemical Society.

[24]  R. Timmons,et al.  Plasma Synthesis of a Novel CF3-Dominated Fluorocarbon Film , 1996 .

[25]  Yolanda Y. Davidson,et al.  Surface modification of poly(methyl methacrylate) used in the fabrication of microanalytical devices. , 2000, Analytical chemistry.

[26]  H. Becker,et al.  Polymer microfluidic devices. , 2002, Talanta.

[27]  Viktor Stein,et al.  Continuous-flow polymerase chain reaction of single-copy DNA in microfluidic microdroplets. , 2009, Analytical chemistry.

[28]  Mitsutoshi Nakajima,et al.  Formulation of monodisperse emulsions using submicron-channel arrays , 2007 .

[29]  Rustem F Ismagilov,et al.  ABO, D blood typing and subtyping using plug-based microfluidics. , 2008, Analytical chemistry.

[30]  G. Whitesides,et al.  Poly(dimethylsiloxane) as a material for fabricating microfluidic devices. , 2002, Accounts of chemical research.

[31]  Johan Roeraade,et al.  Continuous segmented-flow polymerase chain reaction for high-throughput miniaturized DNA amplification. , 2003, Analytical chemistry.

[32]  Rustem F Ismagilov,et al.  Microfluidic cartridges preloaded with nanoliter plugs of reagents: an alternative to 96-well plates for screening. , 2006, Current opinion in chemical biology.

[33]  K. Hiller,et al.  Proliferation of osteoblasts and fibroblasts on model surfaces of varying roughness and surface chemistry , 2007, Journal of materials science. Materials in medicine.

[34]  G. Kane Jennings,et al.  Structure, Wettability, and Electrochemical Barrier Properties of Self-Assembled Monolayers Prepared from Partially Fluorinated Hexadecanethiols , 2003 .

[35]  I. Rubinstein,et al.  Self-Assembled Monolayers on Oxidized Metals. 2. Gold Surface Oxidative Pretreatment, Monolayer Properties, and Depression Formation , 1998 .

[36]  Holger Becker,et al.  Polymer microfabrication technologies for microfluidic systems , 2008, Analytical and bioanalytical chemistry.

[37]  Saif A. Khan,et al.  Transport and reaction in microscale segmented gas-liquid flow. , 2004, Lab on a chip.

[38]  E. Borguet,et al.  Fluorescence labeling and quantification of oxygen-containing functionalities on the surface of single-walled carbon nanotubes. , 2009, Langmuir : the ACS journal of surfaces and colloids.

[39]  D. Castner,et al.  Regularization: A stable and accurate method for generating depth profiles from angle‐dependent XPS data , 1989 .

[40]  Steven A Soper,et al.  Designing highly specific biosensing surfaces using aptamer monolayers on gold. , 2006, Langmuir : the ACS journal of surfaces and colloids.

[41]  Dae Kun Hwang,et al.  Microfluidic-based synthesis of non-spherical magnetic hydrogel microparticles. , 2008, Lab on a chip.

[42]  Li-Jen Chen,et al.  Contact angle hysteresis on regular pillar-like hydrophobic surfaces. , 2008, Langmuir : the ACS journal of surfaces and colloids.

[43]  J. Burns,et al.  The intensification of rapid reactions in multiphase systems using slug flow in capillaries. , 2001, Lab on a chip.

[44]  D. Fischer,et al.  Water-based non-stick hydrophobic coatings , 1994, Nature.