Characterization and modeling of 2D-glass micro-machining by spark-assisted chemical engraving (SACE) with constant velocity

Spark-assisted chemical engraving (SACE) is an unconventional micro-machining technology based on electrochemical discharge used for micro-machining nonconductive materials. SACE 2D micro-machining with constant speed was used to machine micro-channels in glass. Parameters affecting the quality and geometry of the micro-channels machined by SACE technology with constant velocity were presented and the effect of each of the parameters was assessed. The effect of chemical etching on the geometry of micro-channels under different machining conditions has been studied, and a model is proposed for characterization of the micro-channels as a function of machining voltage and applied speed.

[1]  Hannes Bleuler,et al.  The current signal in spark-assisted chemical engraving (SACE): what does it tell us? , 2006 .

[2]  S. K. Choudhury,et al.  On the machining of alumina and glass , 2002 .

[3]  Hannes Bleuler,et al.  Geometrical characterization of micro-holes drilled in glass by gravity-feed with spark assisted chemical engraving (SACE) , 2007 .

[4]  B. Bhattacharyya,et al.  Experimental investigations into electrochemical discharge machining (ECDM) of non-conductive ceramic materials , 1999 .

[5]  N. H. Cook,et al.  Experimental Studies in Electro-Machining , 1973 .

[6]  Rolf Wüthrich,et al.  Study of Spark Assisted Chemical Engraving – Process Technology Data , 2002 .

[7]  Spark Assisted Chemical Engraving : A Novel Technology for Glass Microstructuring , 2003 .

[8]  H. Bleuler,et al.  Investigations of the spark-assisted chemical engraving , 2003 .

[9]  B. Yan,et al.  3D microstructuring of Pyrex glass using the electrochemical discharge machining process , 2007 .

[10]  Sang Jo Lee,et al.  Improvement of surface integrity of electro-chemical discharge machining process using powder-mixed electrolyte , 2007 .

[11]  V. Fascio,et al.  In situ measurement and micromachining of glass , 1999, MHS'99. Proceedings of 1999 International Symposium on Micromechatronics and Human Science (Cat. No.99TH8478).

[12]  V. Jain,et al.  ELECTROCHEMICAL SPARK TREPANNING OF ALUMINA AND QUARTZ , 2000 .

[13]  V. Fascio,et al.  Machining of non-conducting materials using electrochemical discharge phenomenon – An overview , 2005 .

[14]  Yunn-Shiuan Liao,et al.  Study of Hole-Machining on Pyrex Wafer by Electrochemical Discharge Machining (ECDM) , 2006 .