Adsorption cooling cycles for alternative adsorbent/adsorbate pairs working at partial vacuum and pressurized conditions

Abstract This article presents the performance analysis of both ideal single-stage and single-effect double-lift adsorption cooling cycles working at partially evacuated and pressurized conditions. Six specimens of adsorbents and refrigerant pairs, i.e., ACF (A-15)/ethanol, ACF (A-20)/ethanol, silica gel/water, Chemviron/R134a, Fluka/R134a and MaxsorbII/R134a have been investigated. The relationships between equilibrium pressures, adsorbent temperatures and equilibrium adsorption concentrations (Duhring diagram) are presented. Parametric analyses have been carried out with various regeneration (desorption) and evaporation temperatures. Theoretical analysis for adsorption cycles working in single-stage mode shows that ACF (A-20)/ethanol can achieve a specific cooling effect (SCE) of 344 kJ/kg_ads, which is followed by the silica gel/water pair with 217 kJ/kg_ads at a regeneration temperature of 85 °C. On the other hand, when the regeneration temperature is below 70 °C, single-effect double-lift cycle has a significant advantage over single-stage cycle, at which the SCE is higher due to the reduction in adsorption bed pressure in single-effect double-lift cycle.

[1]  Takao Kashiwagi,et al.  Computer simulation of a silica gel-water adsorption refrigeration cycle - the influence of operating conditions on cooling output and COP , 1995 .

[2]  K. Ng,et al.  Waste heat driven dual-mode, multi-stage, multi-bed regenerative adsorption system , 2003 .

[3]  Takao Kashiwagi,et al.  Study on solar/waste heat driven multi-bed adsorption chiller with mass recovery , 2007 .

[4]  Takao Kashiwagi,et al.  Experimental investigation of a silica gel-water adsorption refrigeration cycle -- The influence of operating conditions on cooling output and COP , 1995 .

[5]  R. Vogel,et al.  Possible adsorption pairs for use in solar cooling , 1986 .

[6]  D. I. Tchernev,et al.  High-efficiency regenerative zeolite heat pump , 1988 .

[7]  Kim Choon Ng,et al.  Experimental investigation of activated carbon fibers/ethanol pairs for adsorption cooling system application , 2006 .

[8]  Pradip Dutta,et al.  Evaluation of minimum desorption temperatures of thermal compressors in adsorption refrigeration cycles , 2006 .

[9]  N. D. Banker,et al.  Performance analysis of activated carbon + HFC-134a adsorption coolers , 2004 .

[10]  Qun Cui,et al.  Environmentally benign working pairs for adsorption refrigeration , 2005 .

[11]  Giovanni Restuccia,et al.  Reversible adsorption heat pump: a thermodynamic model , 1995 .

[12]  P. Dutta,et al.  Effect of packing density and adsorption parameters on the throughput of a thermal compressor , 2002 .

[13]  Ruzhu Wang,et al.  Study on a New Solid Absorption Refrigeration Pair: Active Carbon Fiber—Methanol , 1997 .

[14]  F. Meunier,et al.  Thermodynamic performance improvement of an intermittent solar-powered refrigeration cycle using adsorption of methanol on activated carbon , 1986 .

[15]  Ruzhu Wang,et al.  The performance of two adsorption ice making test units using activated carbon and a carbon composite as adsorbents , 2006 .

[16]  Ruzhu Wang,et al.  A review on adsorption working pairs for refrigeration , 2009 .

[17]  Takao Kashiwagi,et al.  Solar/waste heat driven two-stage adsorption chiller: the prototype , 2001 .

[18]  Takao Kashiwagi,et al.  Performance evaluation of a two-stage adsorption refrigeration cycle with different mass ratio , 2005 .

[19]  Robert E. Critoph,et al.  Activated carbon adsorption cycles for refrigeration and heat pumping , 1989 .

[20]  KIM CHOON NG.  Thermodynamic Tools for Chiller Diagnostics and Optimization , 2004 .

[21]  K. Ng,et al.  Two-Stage Non-Regenerative Silica Gel-Water Adsorption Refrigeration Cycle , 2000, Advanced Energy Systems.

[22]  Takao Kashiwagi,et al.  Study on a dual-mode, multi-stage, multi-bed regenerative adsorption chiller , 2006 .