An aircraft cabin acoustic enclosure, built in support of the Propfan Test Assessment (PTA) program, is described. Helmholtz resonators were attached to the cabin trim panels to increase the sidewall transmission loss (TL). Resonators (448) were located between the trim panels and fuselage shell. In addition, 152 resonators were placed between the enclosure and aircraft floors. The 600 resonators were each tuned to a 235 Hz resonance frequency. After flight testing on the PTA aircraft, the enclosure was tested in the Kelly Johnson R and D Center Acoustics Lab. Laboratory noise reduction (NR) test results are discussed. The enclosure was placed in a Gulfstream 2 fuselage section. Broadband (138 dB overall SPL) and tonal (149 dB overall SPL) excitations were used in the lab. Tonal excitation simulated the propfan flight test excitation. The fundamental tone was stepped in 2 Hz intervals from 225 through 245 Hz. The resonators increase the NR of the cabin walls around the resonance frequency of the resonator array. The effects of flanking, sidewall absorption, cabin adsorption, resonator loading of trim panels, and panel vibrations are presented. Increases in NR of up to 11 dB were measured.
[1]
B. H. Little,et al.
Propfan Test Assessment (PTA)
,
1989
.
[2]
John F. Wilby.
Propeller aircraft interior noise
,
1982
.
[3]
J. F. Wilby,et al.
Propeller aircraft interior noise model
,
1984
.
[4]
H. L. Kuntz,et al.
Transmission loss of double wall panels containing Helmholtz resonators
,
1988
.
[5]
H. L. Kuntz,et al.
Interior noise in the untreated Gulfstream II Propfan Test Assessment aircraft
,
1990
.
[6]
U. Ingard.
The Near Field of a Helmholtz Resonator Exposed to a Plane Wave
,
1953
.
[7]
L. D. Pope,et al.
Transmission loss of a multilayer panel with internal tuned Helmholtz resonators
,
1990
.