Vertically Aligned One-Dimensional Crystal-Structured Sb2Se3 for High-Efficiency Flexible Solar Cells via Regulating Selenization Kinetics.

Recently, antimony selenide (Sb2Se3) has exhibited an exciting potential for flexible photoelectric applications due to its unique one-dimensional (1D) chain-type crystal structure, low-cost constituents, and superior optoelectronic properties. The 1D structure endows Sb2Se3 with a strong anisotropy in carrier transport and a lasting mechanical deformation tolerance. The control of the crystalline orientation of the Sb2Se3 film is an essential requirement for its device performance optimization. However, the current state-of-the-art Sb2Se3 devices suffer from unsatisfactory orientation control, especially for the (001) orientation, in which the chains stand vertically. Herein, we achieved an unprecedented control of the (001) orientation for the growth of the Sb2Se3 film on a flexible Mo-coated mica substrate by balancing the collision rate and kinetic energy of Se vapor particles with the surface of Sb film by regulating the selenization kinetics. Based on this (001)-oriented Sb2Se3 film, a high efficiency of 8.42% with a record open-circuit voltage (VOC) of 0.47 V is obtained for flexible Sb2Se3 solar cells. The vertical van der Waals gaps in the (001) orientation provide favorable diffusion paths for Se atoms, which results in a Se-rich state at the bottom of the Sb2Se3 film and promotes the in situ formation of the MoSe2 interlayer between Mo and Sb2Se3. These phenomena contribute to a back-surface field enhanced absorber layer and a quasi-Ohmic back contact, improving the device's VOC and the collection of carriers. This method provides an effective strategy for the orientation control of 1D materials for efficient photoelectric devices.

[1]  Jianhua Zhou,et al.  Self-hygroscopic and smart color-changing hydrogels as coolers for improving energy conversion efficiency of electronics , 2023, Nano Energy.

[2]  R. Schropp,et al.  High-Efficiency Flexible Sb2Se3 Solar Cells by Back Interface and Absorber Bulk Deep-Level Trap Engineering , 2022, ACS Energy Letters.

[3]  Xiaolei Shi,et al.  A-site cation engineering enables oriented Ruddlesden-Popper perovskites towards efficient solar cells , 2022, Science China Chemistry.

[4]  R. Tang,et al.  Interfacial Engineering towards Enhanced Photovoltaic Performance of Sb2Se3 Solar Cell , 2022, Advanced Functional Materials.

[5]  R. Liu,et al.  Synergetic Regulation of Oriented Crystallization and Interfacial Passivation Enables 19.1% Efficient Wide‐Bandgap Perovskite Solar Cells , 2022, Advanced Energy Materials.

[6]  W. Mai,et al.  Underwater Multispectral Computational Imaging Based on a Broadband Water-Resistant Sb2Se3 Heterojunction Photodetector. , 2022, ACS nano.

[7]  D. Friedrich,et al.  Sulfur Treatment Passivates Bulk Defects in Sb2Se3 Photocathodes for Water Splitting , 2022, Advanced Functional Materials.

[8]  Jiang Tang,et al.  Heterojunction Annealing Enabling Record Open‐Circuit Voltage in Antimony Triselenide Solar Cells , 2022, Advanced materials.

[9]  Xianghua Zhang,et al.  Crystal Growth Promotion and Defects Healing Enable Minimum Open‐Circuit Voltage Deficit in Antimony Selenide Solar Cells , 2022, Advanced science.

[10]  H. Ouyang,et al.  Shape‐Engineerable Silk Fibroin Papers for Ideal Substrate Alternatives of Plastic Electronics (Adv. Funct. Mater. 52/2021) , 2021, Advanced Functional Materials.

[11]  M. Heben,et al.  Templated Growth and Passivation of Vertically Oriented Antimony Selenide Thin Films for High‐Efficiency Solar Cells in Substrate Configuration , 2021, Advanced Functional Materials.

[12]  Jiang Tang,et al.  One-dimensional Sb2Se3 enabling ultra-flexible solar cells and mini-modules for IoT applications , 2021 .

[13]  X. Gong,et al.  More Se Vacancies in Sb2 Se3 under Se-Rich Conditions: An Abnormal Behavior Induced by Defect-Correlation in Compensated Compound Semiconductors. , 2021, Small.

[14]  Zuoyun Wang,et al.  Boosting V OC of antimony chalcogenide solar cells: A review on interfaces and defects , 2021, Nano Select.

[15]  Gwo-Ching Wang,et al.  Efficient and stable flexible Sb2Se3 thin film solar cells enabled by an epitaxial CdS buffer layer , 2021, Nano Energy.

[16]  T. Minemoto,et al.  Back-contact barrier analysis to develop flexible and bifacial Cu(In,Ga)Se2 solar cells using transparent conductive In2O3: SnO2 thin films , 2020 .

[17]  M. Green,et al.  Hydrothermal deposition of antimony selenosulfide thin films enables solar cells with 10% efficiency , 2020, Nature Energy.

[18]  Gwo-Ching Wang,et al.  High-Crystallinity Epitaxial Sb2Se3 Thin Film on Mica for Flexible Near-Infrared Photodetectors. , 2020, ACS applied materials & interfaces.

[19]  Jiang Tang,et al.  Efficiency improvement of flexible Sb2Se3 solar cells with non-toxic buffer layer via interface engineering , 2020 .

[20]  Zhizhong Chen,et al.  Epitaxial CdTe Thin Films on Mica by Vapor Transport Deposition for Flexible Solar Cells , 2020 .

[21]  Zhibin Yu,et al.  A review of flexible halide perovskite solar cells towards scalable manufacturing and environmental sustainability , 2020, Journal of Semiconductors.

[22]  J. S. Lee,et al.  Benchmark performance of low-cost Sb2Se3 photocathodes for unassisted solar overall water splitting , 2020, Nature Communications.

[23]  Zhong Lin Wang,et al.  Dual-polarity response in self-powered ZnO NWs/Sb2Se3 film heterojunction photodetector array for optical communication , 2020 .

[24]  Fu Li,et al.  One-Dimensional Sb2Se3 Enabling a Highly Flexible Photodiode for Light-Source-Free Heart Rate Detection , 2020 .

[25]  Jiang Tang,et al.  Orientation Engineering in Low‐Dimensional Crystal‐Structural Materials via Seed Screening , 2019, Advanced materials.

[26]  Shaojun Guo,et al.  A 3D Trilayered CNT/MoSe2/C Heterostructure with an Expanded MoSe2 Interlayer Spacing for an Efficient Sodium Storage , 2019, Advanced Energy Materials.

[27]  Jiangyu Li,et al.  Highly flexible, robust, stable and high efficiency perovskite solar cells enabled by van der Waals epitaxy on mica substrate , 2019, Nano Energy.

[28]  R. Schropp,et al.  9.2%-efficient core-shell structured antimony selenide nanorod array solar cells , 2019, Nature Communications.

[29]  Guangda Niu,et al.  Vapor transport deposition of antimony selenide thin film solar cells with 7.6% efficiency , 2018, Nature Communications.

[30]  Chung‐Hsin Lu,et al.  Effects of Mo films prepared via different sputtering conditions on the formation of MoSe2 during selenization , 2018 .

[31]  Liang Gao,et al.  Magnetron sputtered ZnO buffer layer for Sb2Se3 thin film solar cells , 2017 .

[32]  G. Wang,et al.  Enhanced Sb2Se3 solar cell performance through theory‐guided defect control , 2017 .

[33]  J. Qiu,et al.  Emerging Low‐Dimensional Materials for Nonlinear Optics and Ultrafast Photonics , 2017, Advanced materials.

[34]  Liang Gao,et al.  Stable 6%-efficient Sb2Se3 solar cells with a ZnO buffer layer , 2017, Nature Energy.

[35]  Y. Mai,et al.  Sb2Se3 thin film solar cells in substrate configuration and the back contact selenization , 2017 .

[36]  Liang Gao,et al.  Ambient CdCl2 treatment on CdS buffer layer for improved performance of Sb2Se3 thin film photovoltaics , 2015 .

[37]  Seong Sik Shin,et al.  High-performance flexible perovskite solar cells exploiting Zn2SnO4 prepared in solution below 100 °C , 2015, Nature Communications.

[38]  Jiang Tang,et al.  Thin-film Sb2Se3 photovoltaics with oriented one-dimensional ribbons and benign grain boundaries , 2015, Nature Photonics.

[39]  Jiang Tang,et al.  Thermal evaporation and characterization of Sb2Se3 thin film for substrate Sb2Se3/CdS solar cells. , 2014, ACS applied materials & interfaces.

[40]  I. M. Dharmadasa,et al.  High short-circuit current density CdTe solar cells using all-electrodeposited semiconductors , 2014 .

[41]  Shiro Nishiwaki,et al.  Doping of polycrystalline CdTe for high-efficiency solar cells on flexible metal foil , 2013, Nature Communications.

[42]  A. S. Kavasoglu,et al.  Tunnelling enhanced recombination in polycrystalline CdS/CdTe and CdS/Cu(In,Ga)Se2 heterojunction solar cells , 2005 .

[43]  Steven S. Hegedus,et al.  Thin‐film solar cells: device measurements and analysis , 2004 .

[44]  J. Sites,et al.  Diode quality factor determination for thin-film solar cells , 1989 .