Numerical evaluation of a solar chimney geometry for different ground temperatures by means of constructal design

The present work aims to numerically study the influence of geometric parameters over the available power of solar chimney power plant (SCPP) by means of Constructal Design. The influence of different imposed ground temperatures (mimicking the effect of different solar incidence on collector device) over the optimal shapes is also evaluated. The geometry is submitted to three constraints: collector, turbine and chimney areas. Moreover, three degrees of freedom are taken into account: R/H (ratio between collector radius and its inlet height), R1/H2 (ratio between the radius and height of chimney) and H1/H (ratio between the height of collector base and collector inlet height) which is constant (H1/H = 10.0). The mixed convective flow is incompressible, turbulent, steady, in two-dimensional axisymmetric domain. Time-averaged conservation equations of mass, momentum and energy (RANS) are numerically solved using the finite volume method (FVM). For closure modeling of turbulence it is employed the standard k – e model. Results showed a strong influence of the chimney and collector geometry over the available power. Moreover, geometric parameters of collector and chimney must be evaluated in a combined way. It was also noticed a large sensibility of the ground temperature over the available power and geometric effects.

[1]  Theodor W. von Backström,et al.  Solar Chimney cycle analysis with system loss and solar collector performance. , 2000 .

[2]  A. Bejan.  Shape and Structure, from Engineering to Nature , 2000 .

[3]  Wolfgang Schiel,et al.  Design of Commercial Solar Updraft Tower Systems—Utilization of Solar Induced Convective Flows for Power Generation , 2005 .

[4]  Detlev G. Kröger,et al.  Critical evaluation of solar chimney power plant performance , 2006 .

[5]  S. A. Sherif,et al.  Experimental and theoretical performance of a demonstration solar chimney model—Part I: mathematical model development , 1998 .

[6]  A. Mohammadi,et al.  Optimum dimension of geometric parameters of solar chimney power plants – A multi-objective optimization approach , 2014 .

[7]  Majid Amidpour,et al.  Modeling and numerical simulation of solar chimney power plants , 2011 .

[8]  Rakesh Khanal,et al.  A numerical investigation of buoyancy induced turbulent air flow in an inclined passive wall solar chimney for natural ventilation , 2015 .

[9]  Xinping Zhou,et al.  Experimental study of temperature field in a solar chimney power setup , 2007 .

[10]  Oliver Kornadt,et al.  Numerical and analytical calculations of the temperature and flow field in the upwind power plant , 2004 .

[11]  Yunfeng Wang,et al.  Numerical study on the performance of a solar chimney power plant , 2015 .

[12]  Liércio André Isoldi,et al.  Constructal Design Applied to the Geometric Optimization of Y-shaped Cavities Embedded in a Conducting Medium , 2011 .

[13]  A. Bejan,et al.  The constructal law and the evolution of design in nature. , 2011, Physics of life reviews.

[14]  A. Bejan.  Convection Heat Transfer , 1984 .

[15]  J. Schlaich,et al.  Solar Chimneys Part I: Principle and Construction of the Pilot Plant in Manzanares , 1983 .

[16]  Deepak Prasad,et al.  Computational studies on the effect of geometric parameters on the performance of a solar chimney power plant , 2014 .

[17]  A. Bejan,et al.  Constructal solar chimney configuration , 2010 .

[18]  Adrian Bejan,et al.  Design with constructal theory , 2008 .

[19]  B. Launder,et al.  Lectures in mathematical models of turbulence , 1972 .

[20]  Weeratunge Malalasekera,et al.  An introduction to computational fluid dynamics - the finite volume method , 2007 .

[21]  A. Bejan,et al.  Constructal law and the unifying principle of design , 2013 .

[22]  W. Haaf,et al.  Solar Chimneys: Part II: Preliminary Test Results from the Manzanares Pilot Plant , 1984 .

[23]  Fang Wang,et al.  A review of solar chimney power technology , 2010, Renewable and Sustainable Energy Reviews.

[24]  Gongnan Xie,et al.  Constructal Design Associated to Genetic Algorithm of Asymmetric V-Shaped Pathways , 2015 .

[25]  Weibing Li,et al.  A cost-benefit analysis of power generation from commercial reinforced concrete solar chimney power plant , 2014 .

[26]  Alibakhsh Kasaeian,et al.  Experimental study of geometrical and climate effects on the performance of a small solar chimney , 2015 .

[27]  Ramon Molina Valle,et al.  Numerical analysis of natural laminar convection in a radial solar heater , 1999 .

[28]  Elizaldo Domingues dos Santos,et al.  CONSTRUCTAL DESIGN APPLIED TO THE STUDY OF THE GEOMETRY AND SUBMERGENCE OF AN OSCILLATING WATER COLUMN , 2015 .

[29]  Joaquim Vaz,et al.  Numerical investigation about the improvement of the thermal potential of an Earth-Air Heat Exchanger (EAHE) employing the Constructal Design method , 2015 .

[30]  Amel Dhahri,et al.  A Review of solar Chimney Power Generation Technology , 2013 .

[31]  Gongnan Xie,et al.  Optimization of Pin-Fins for a Heat Exchanger by Entropy Generation Minimization and Constructal Law , 2015 .

[32]  Hussain H. Al-Kayiem,et al.  Historic and recent progress in solar chimney power plant enhancing technologies , 2016 .

[33]  Man-Hoe Kim,et al.  Thermo-economic triple-objective optimization of a solar chimney power plant using genetic algorithms , 2014 .

[34]  S. C. Kaushik,et al.  Experimental investigation and CFD simulation studies of a laboratory scale solar chimney for power generation , 2016 .

[35]  Tingzhen Ming,et al.  Numerical analysis on the solar updraft power plant system with a blockage , 2013 .

[36]  Gongnan Xie,et al.  A comparison of simulated annealing schedules for constructal design of complex cavities intruded into conductive walls with internal heat generation , 2015 .

[37]  Amir Rezaei Shahreza,et al.  Experimental and numerical investigation on an innovative solar chimney , 2015 .

[38]  D. Wilcox.  Turbulence modeling for CFD , 1993 .

[39]  Zhihui Xie,et al.  Geometry optimization of T-shaped cavities according to constructal theory , 2010, Math. Comput. Model..

[40]  S. Patankar.  Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.

[41]  Yuan Wang,et al.  Numerical simulations of solar chimney power plant with radiation model , 2014 .

[42]  Adrian Bejan,et al.  Design in Nature , 2012 .

[43]  Alibakhsh Kasaeian,et al.  Experimental investigation of climatic effects on the efficiency of a solar chimney pilot power plant , 2011 .

[44]  O. Joneydi Shariatzadeh,et al.  Evolution in the Design of V-Shaped Highly Conductive Pathways Embedded in a Heat-Generating Piece , 2015 .