In the current code requirements for the design of base isolation systems for buildings located at near-fault sites, the design engineer is faced with very large design displacements for the isolators. To reduce these displacements, supplementary dampers are often prescribed. These dampers reduce displacements, but at the expense of significant increases in interstorey drifts and floor accelerations in the superstructure. An elementary analysis based on a simple model of an isolated structure is used to demonstrate this dilemma. The model is linear and is based on modal analysis, but includes the modal coupling terms caused by high levels of damping in the isolation system. The equations are solved by a method that avoids complex modal analysis. Estimates of the important response quantities are obtained by the response spectrum method. It is shown that as the damping in the isolation system increases, the contribution of the modal coupling terms due to isolator damping in response to the superstructure becomes the dominant term. The isolator displacement and structural base shear may be reduced, but the floor accelerations and interstorey drift are increased. The results show that the use of supplemental dampers in seismic isolation is a misplaced effort and alternative strategies to solve the problem are suggested. Copyright © 1999 John Wiley & Sons, Ltd.
[1]
James M. Kelly,et al.
Base Isolation: Linear Theory and Design
,
1990
.
[2]
Marvin W. Halling,et al.
Near-Source Ground Motion and its Effects on Flexible Buildings
,
1995
.
[3]
D. Wald,et al.
Response of High-Rise and Base-Isolated Buildings to a Hypothetical Mw 7.0 Blind Thrust Earthquake
,
1995,
Science.
[4]
Kazuhiko Kawashima,et al.
MODIFICATION OF EARTHQUAKE RESPONSE SPECTRA WITH RESPECT TO DAMPING
,
1984
.
[5]
Roger P. Young,et al.
Seismic isolation design of the San Bernardino County Medical Center replacement project
,
1996
.