A coefficient matrix GPM method to avoid joint limits for fault tolerant redundant manipulators

When joint failure occurs in a redundant manipulator, it is required that the end-effector (EEF) continues the trajectory with a minimum velocity jump. This problem has been studied by the joint velocity redistribution method which means mapping the velocity of the faulty joint into healthy joints'. This method can tolerant joint fault successfully but may make joints out of their regions. Therefore the gradient projection method (GPM) is adopted to avoid the redistributed joint limits in this paper. With regard to the selection of the scalar coefficient of GPM, an improved method called the coefficient matrix is proposed. Not only can this method avoid joint limits successfully but also reduce the unnecessary self-motion and control the self-motion of each joint separately. At last the coefficient matrix method is tested in a seven-degree-of-freedom (7-DOF) manipulator and the simulation results indicate the efficiency of this method.

[1]  Rajiv V. Dubey,et al.  Real-time implementation of an optimization scheme for seven-degree-of-freedom redundant manipulators , 1991, IEEE Trans. Robotics Autom..

[2]  Rajiv V. Dubey,et al.  A weighted least-norm solution based scheme for avoiding joint limits for redundant manipulators , 1993, [1993] Proceedings IEEE International Conference on Robotics and Automation.

[3]  Joseph R. Cavallaro,et al.  Failure mode analysis for a hazardous waste clean-up manipulator , 1996 .

[4]  Anthony A. Maciejewski,et al.  A local measure of fault tolerance for kinematically redundant manipulators , 1996, IEEE Trans. Robotics Autom..

[5]  Wan Kyun Chung,et al.  Failure recoverability by exploiting kinematic redundancy , 1996, Proceedings 5th IEEE International Workshop on Robot and Human Communication. RO-MAN'96 TSUKUBA.

[6]  Dinesh K. Pai,et al.  Computing fault tolerant motions for a robot manipulator , 1999, Proceedings 1999 IEEE International Conference on Robotics and Automation (Cat. No.99CH36288C).

[7]  Leila Notash.  Joint sensor fault detection for fault tolerant parallel manipulators , 2000 .

[8]  Rodney G. Roberts,et al.  Fault-tolerant kinematically redundant robots , 2002, Proceedings of the Thirty-Fourth Southeastern Symposium on System Theory (Cat. No.02EX540).

[9]  Xue Chang-xing.  Several Integral Inequalities and their Application , 2004 .

[10]  Anthony A. Maciejewski,et al.  Failure-tolerant path planning for kinematically redundant manipulators anticipating locked-joint failures , 2006, IEEE Transactions on Robotics.

[11]  Anthony A. Maciejewski,et al.  Fundamental Limitations on Designing Optimally Fault-Tolerant Redundant Manipulators , 2008, IEEE Transactions on Robotics.

[12]  Zhao Jing,et al.  On the joint velocity jump during fault tolerant operations for manipulators with multiple degrees of redundancy , 2009 .

[13]  Liu Hong.  Gradient projection method of kinematic redundant manipulator based on continuous scale factor , 2009 .

[14]  Ji Xiang,et al.  General-Weighted Least-Norm Control for Redundant Manipulators , 2010, IEEE Transactions on Robotics.

[15]  Saeid Nahavandi,et al.  Fault tolerance force for redundant manipulators , 2010, 2010 2nd International Conference on Advanced Computer Control.

[16]  Saeid Nahavandi,et al.  Joint velocity redistribution for fault tolerant manipulators , 2010, 2010 IEEE Conference on Robotics, Automation and Mechatronics.

[17]  Cai Zi-xing.  Simulation Experimental Teaching of Robotics Based on MATLAB Robotics Toolbox , 2010 .

[18]  Anthony A. Maciejewski,et al.  Optimal mapping of joint faults into healthy joint velocity space for fault-tolerant redundant manipulators , 2011, Robotica.

[19]  Saeid Nahavandi,et al.  Well-conditioned configurations of fault-tolerant manipulators , 2012, Robotics Auton. Syst..

[20]  Dongsheng Guo,et al.  A New Inequality-Based Obstacle-Avoidance MVN Scheme and Its Application to Redundant Robot Manipulators , 2012, IEEE Transactions on Systems, Man, and Cybernetics, Part C (Applications and Reviews).

[21]  Irene M. Moroz,et al.  Several integral inequalities and their applications in nonlinear differential systems , 2013, Appl. Math. Comput..

[22]  Ji Xiang,et al.  Kinematic control for redundant manipulators with time dependent constraints: General-Weighted Least-Norm method , 2014, The 26th Chinese Control and Decision Conference (2014 CCDC).

[23]  Guo Shuli,et al.  Fuzzy observer and fuzzy controller design for a class of uncertain non-linear systems , 2016 .