A Low Friction Bearing Based on Liquid Slip at the Wall

In recent years it has been shown experimentally by a number of workers that simple, Newtonian liquids can slip against solid surfaces when the latter are both very smooth and lyophobic. It has also been shown theoretically how, based on a half-wetted bearing principle, this phenomenon may be used to significantly reduce friction in lubricated sliding contacts and thus make possible the hydrodynamic lubrication of very low load contacts. This paper describes the experimental validation of this concept. A low load bearing is constructed and the influence of surface roughness and the wetting properties of the surfaces on friction are investigated over a wide range of sliding speeds. It is shown that liquid slip can be used to considerably reduce friction in full film, hydrodynamic conditions.

[1]  Chengwei Wu,et al.  Abnormal behavior of a hydrodynamic lubrication journal bearing caused by wall slip , 2005 .

[2]  S. Granick,et al.  Rate-dependent slip of Newtonian liquid at smooth surfaces. , 2001, Physical review letters.

[3]  S. Granick,et al.  Self-Assembled Monolayers on Mica for Experiments Utilizing the Surface Forces Apparatus , 1995 .

[4]  H. Spikes.  The half-wetted bearing. Part 1: Extended Reynolds equation , 2003 .

[5]  O. Vinogradova.  Slippage of water over hydrophobic surfaces , 1999 .

[6]  A. Cameron.  Basic lubrication theory , 1976 .

[7]  Richard F. Salant,et al.  Numerical Analysis of a Journal Bearing With a Heterogeneous Slip/No-Slip Surface , 2005 .

[8]  H. Spikes,et al.  Friction reduction in low-load hydrodynamic lubrication with a hydrophobic surface , 2007 .

[9]  Lydéric Bocquet,et al.  Large Slip Effect at a Nonwetting Fluid-Solid Interface , 1999 .

[11]  D. Williams,et al.  Shear-dependent boundary slip in an aqueous Newtonian liquid. , 2001, Physical review letters.

[12]  Andreas Opitz,et al.  The effect of wetting on the microhydrodynamics of surfaces lubricated with water and oil , 2003 .

[13]  Hugh Spikes,et al.  Equation for Slip of Simple Liquids at Smooth Solid Surfaces , 2003 .

[14]  S. Troian,et al.  A general boundary condition for liquid flow at solid surfaces , 1997, Nature.

[15]  N. Giordano,et al.  Fluid flow through nanometer-scale channels. , 2002, Physical review. E, Statistical, nonlinear, and soft matter physics.

[16]  Robbins,et al.  Shear flow near solids: Epitaxial order and flow boundary conditions. , 1990, Physical review. A, Atomic, molecular, and optical physics.

[17]  L. Léger,et al.  Wall slip in polymer melts , 1997 .

[18]  L. Léger,et al.  Direct experimental evidence of slip in hexadecane: solid interfaces , 2000, Physical review letters.

[19]  Hugh Spikes,et al.  The Frictional Properties of Newtonian Fluids in Rolling–Sliding soft-EHL Contact , 2005 .

[20]  I. Marrucho,et al.  Surface Tension of Heptane, Decane, Hexadecane, Eicosane, and Some of Their Binary Mixtures , 2002 .

[21]  C. Meinhart,et al.  Apparent fluid slip at hydrophobic microchannel walls , 2002 .

[22]  J. Chappuis.  Lubrication by a new principle: The use of non-wetting liquids , 1982 .

[23]  H. Spikes.  The half-wetted bearing. Part 2: Potential application in low load contacts , 2003 .

[24]  S. Granick,et al.  Limits of the hydrodynamic no-slip boundary condition. , 2002, Physical review letters.

[25]  Hans-Jürgen Butt,et al.  Hydrodynamic force measurements: boundary slip of water on hydrophilic surfaces and electrokinetic effects. , 2002, Physical review letters.

[26]  S. Granick,et al.  Formation and Characterization of a Highly Ordered and Well- Anchored Alkylsilane Monolayer on Mica by Self -Assembly , 1991 .

[27]  Liliane Léger,et al.  Friction and slip of a simple liquid at a solid surface , 1999 .