Microllular plastics are cellular polymers characterized by cell densities greater than 109 cells/cm3 and cells smaller than 10 μm. One of the critical steps in the continuous production of microcellular plastics is the promotion of high cell nucleation rates in a flowing polymer matrix. These high nucleation rates can be achieved by first forming a polymer/gas solution followed by rapidly decreasing the solubility of gas in the polymer. Since, in the processing range of interest, the gas solubility in the polymer decreases as the pressure decreases, a rapid pressure drop element, consisting of a nozzle, has been employed as a continuous microcellular nucleation device. In this paper, the effects of the pressure drop rate on the nucleation of cells and the cell density are discussed. The experimental results indicate that both the magnitude and the cell density are discussed. The experimental results indicate that both the magnitude and the rate of pressure drop play a strong role in microcellular processing. The pressure phenomenon affects the thermodynamic instability induced in the polymer/gas solution and the competition between cell nucleation and growth.
[1]
R. Bird.
Dynamics of Polymeric Liquids
,
1977
.
[2]
N. Suh,et al.
A process for making microcellular thermoplastic parts
,
1990
.
[3]
R. G. Griskey,et al.
Diffusion and solution of gases into thermally softened or molten polymers: Part II. Relation of diffusivities and solubilities with temperature pressure and structural characteristics
,
1969
.
[4]
Jonathan S. Colton,et al.
Nucleation of microcellular foam: Theory and practice
,
1987
.
[5]
R. G. Griskey,et al.
Diffusion and solution of gases in thermally softened or molten polymers: Part I. Development of technique and determination of data
,
1966
.
[6]
Karl A. Seeler,et al.
Tension-Tension Fatigue of Microcellular Polycarbonate: Initial Results
,
1993
.