High efficiency power amplifier based on envelope elimination and restoration technique

Due to complex envelope and phase modulation employed in modern transmitters it is necessary to use power amplifiers that have high linearity. Linear power amplifiers (classes A, B and AB) are commonly used, but they suffer from low efficiency especially if the transmitted signal has high peak to average power ratio (PAPR). Kahn's technique based on envelope elimination and restoration (EER) is based on idea that high efficiency power supply (envelope amplifier) could be used to modulate the envelope of high efficient non linear power amplifiers (classes D or E). This paper presents solutions for power amplifier that performs envelope modulation and class E amplifier that is used as a non linear amplifier. The envelope amplifier is implemented as a multilevel converter in series with linear regulator and can provide up to 100 W of instantaneous power and reproduce 2 MHz sine wave. The implemented Class E amplifier can operate at 120 MHz with efficiency near to 85%. The envelope amplifier and class E amplifier have been integrated and efficiency and linearity of the implemented transmitter has been measured and presented.

[1]  F. H. Raab,et al.  High-efficiency single-sideband HF/VHF transmitter based upon envelope elimination and restoration , 1994 .

[2]  F. Raab.  Intermodulation distortion in Kahn-technique transmitters , 1996 .

[3]  F. Raab,et al.  L-band transmitter using Kahn EER technique , 1998 .

[4]  George B. Norris,et al.  High efficiency CDMA RF power amplifier using dynamic envelope tracking technique , 2000, 2000 IEEE MTT-S International Microwave Symposium Digest (Cat. No.00CH37017).

[5]  F. Raab,et al.  Power amplifiers and transmitters for RF and microwave , 2002 .

[6]  J.A. Cobos,et al.  Power supply for a radio transmitter with modulated supply voltage , 2004, Nineteenth Annual IEEE Applied Power Electronics Conference and Exposition, 2004. APEC '04..

[7]  T. Oshima,et al.  Simple polar-loop transmitter for dual-mode Bluetooth , 2005, 2005 IEEE International Symposium on Circuits and Systems.

[8]  Eduard Alarcón,et al.  Effects of switching power converter nonidealities in envelope elimination and restoration technique , 2006, 2006 IEEE International Symposium on Circuits and Systems.

[9]  F.J. Ortega-Gonzalez.  Load–Pull Wideband Class-E Amplifier , 2007, IEEE Microwave and Wireless Components Letters.

[10]  Christophe Garnier,et al.  A Single-Chip WCDMA Envelope Reconstruction LDMOS PA with 130MHz Switched-Mode Power Supply , 2008, 2008 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[11]  D. Maksimovic,et al.  A high-efficiency linear polar transmitter for EDGE , 2008, 2008 IEEE Radio and Wireless Symposium.

[12]  M. Hoyerby,et al.  Ultrafast Tracking Power Supply With Fourth-Order Output Filter and Fixed-Frequency Hysteretic Control , 2008, IEEE Transactions on Power Electronics.

[13]  O. Garcia,et al.  Multilevel Power Supply for High Efficiency RF Amplifiers , 2010, 2009 Twenty-Fourth Annual IEEE Applied Power Electronics Conference and Exposition.

[14]  O. Garcia,et al.  High efficiency power amplifier for high frequency radio transmitters , 2010, 2010 Twenty-Fifth Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[15]  Miroslav Vasic.  Wide bandwidth high efficiency power converter for rf amplifiers , 2011 .