CNC milling machine feed drive laboratory stand for purposes of velocity control algorithms prototyping

Article describes extended concept of digital servodrive velocity control algorithms rapid prototyping, which is crucial component of milling machine feed drive equipped with ball screw. Approach presented here describes the case where the user has no access to the internal control structure the servodrive (design widespread in commercially applied CNC solutions), and can only use an additional signal (additive value of torque/current), calculated on the basis of a comparison of the real object and its nominal dynamic model.

[1]  Krzysztof Pietrusewicz,et al.  Hybrid model-following control algorithm within the motion control system , 2009, 2009 IEEE International Symposium on Industrial Electronics.

[2]  Zhigang Liu,et al.  Switching gain adaptive sliding mode model-following speed control of PMSM , 2010, Proceedings of the 29th Chinese Control Conference.

[3]  Lili Zhang,et al.  Research on Nonlinear PID Position Controller of CNC System , 2007, 2007 IEEE International Conference on Automation and Logistics.

[4]  Krzysztof Pietrusewicz,et al.  Eksperymentalny system OCEAN otwartego sterowania napędami liniowymi , 2011 .

[5]  K. Pietrusewicz,et al.  Robust model-following control for the DC servo drive , 2008, 2008 IEEE International Conference on Industrial Technology.

[6]  K. Pietrusewicz,et al.  MFC/IMC system for processes with varying time-delay exemplified by a 4 MW steam boiler , 2004 .

[7]  Gan-lin Shan,et al.  Model-following sliding mode controller design for flight control systems with wind disturbances , 2009, 2009 4th IEEE Conference on Industrial Electronics and Applications.