Development of a simplified resistance and capacitance (RC)-network model for pipe-embedded concrete radiant floors

Abstract Pipe-embedded concrete radiant floor system has gained much popularity due to its higher energy efficiency and better thermal comfort. Simplified yet accurate heat transfer models are essential for energy simulation of this system. This study presents the development and validation of a simplified RC-network model for the pipe-embedded concrete radiant floors. A concrete radiant floor mainly consists of three parts which are the cover layer, the pipe-embedded concrete slab and the insulation layer. The cover layer and the insulation layer are simplified as one-dimensional and represented by RC models with two resistances and one capacitance (2R1C). Within the pipe-embedded concrete slab, the complex heat transfer is represented by a coupled RC model which includes two parts describing the heat transfers of the concrete slab and the water loop respectively. In the case studies, the coupled RC model for the pipe-embedded concrete slab has been validated in both numerical and experimental ways. The experimental validation results show that the average relative errors of the coupled RC model in predicting the upper and bottom surface heat fluxes are all less than 5.5%. Validation has also been conducted to demonstrate the accuracy and effectiveness of this developed simplified RC-network model in predicting the dynamic thermal performance of a multi-layer pipe-embedded concrete radiant floor. The developed simplified RC-network model can be beneficial for design and optimal control of the pipe-embedded concrete radiant floor system.

[1]  Jianjun Hu,et al.  System identification and model-predictive control of office buildings with integrated photovoltaic-thermal collectors, radiant floor heating and active thermal storage , 2015 .

[2]  Richard Karl Strand,et al.  Implementation of a radiant heating and cooling model into an integrated building energy analysis program , 1997 .

[3]  Shengwei Wang,et al.  Simplified building model for transient thermal performance estimation using GA-based parameter identification , 2006 .

[4]  Zhe Tian,et al.  Establishment and experimental validation of a dynamic heat transfer model for concrete radiant cooling slab based on reaction coefficient method , 2014 .

[5]  Michele De Carli,et al.  Radiant floor cooling coupled with dehumidification systems in residential buildings: A simulation-based analysis , 2014 .

[6]  Viktor Dorer,et al.  Control of thermally activated building systems (TABS) in intermittent operation with pulse width modulation , 2009 .

[7]  Mahmut Uludag,et al.  A simplified model for radiant heating and cooling panels , 1994, Simul. Pract. Theory.

[8]  S. Chirarattananon,et al.  Application of radiant cooling as a passive cooling option in hot humid climate , 2007 .

[9]  Henrik Karlsson.  Embedded Water-based Surface Heating Part 1: Hybrid 3D Numerical Model , 2010 .

[10]  Yi Jiang,et al.  Dynamic performance of water-based radiant floors during start-up and high-intensity solar radiation , 2014 .

[11]  Fu Xiao,et al.  Development of dynamic simplified thermal models of active pipe-embedded building envelopes using genetic algorithm , 2014 .

[12]  Richard Karl Strand,et al.  Modeling Radiant Systems in an Integrated Heat Balance Based Energy Simulation Program , 2002 .

[13]  Marta Maria Sesana,et al.  Assessing energy and thermal comfort of different low-energy cooling concepts for non-residential buildings , 2013 .

[14]  O. C. Zienkiewicz,et al.  The Finite Element Method: Its Basis and Fundamentals , 2005 .

[15]  Abdelaziz Laouadi.  Development of a radiant heating and cooling model for building energy simulation software , 2004 .

[16]  Hasan Karabay,et al.  A numerical investigation of fluid flow and heat transfer inside a room for floor heating and wall heating systems , 2013 .

[17]  Jeffrey D. Spitler,et al.  Applicability of calculation methods for conduction transfer function of building constructions , 2009 .

[18]  Martine Baelmans,et al.  Efficiently produced heat and cold is squandered by inappropriate control strategies: A case study , 2009 .

[19]  Lucia Fontana,et al.  Thermal performance of radiant heating floors in furnished enclosed spaces , 2011 .

[20]  Dirk Saelens,et al.  Energy and comfort performance of thermally activated building systems including occupant behavior , 2011 .

[21]  Viktor Dorer,et al.  Control of thermally-activated building systems (TABS) , 2008 .

[22]  Kwang Woo Kim,et al.  A 50 year review of basic and applied research in radiant heating and cooling systems for the built environment , 2015 .

[23]  Michele De Carli,et al.  DIGITHON: A numerical model for the thermal balance of rooms equipped with radiant systems , 2012 .

[24]  Stefan Antonov,et al.  Potential And Parameter Sensitivity Of Model Based Predictive Control For Concrete Core Activation And Air Handling Unit , 2013, Building Simulation Conference Proceedings.

[25]  Yi Jiang,et al.  Simplified calculation for cooling/heating capacity, surface temperature distribution of radiant floor , 2012 .

[26]  Usik Lee,et al.  An FFT-based spectral analysis method for linear discrete dynamic systems with non-proportional damping , 2006 .

[27]  Delfim Soares,et al.  Initial conditions in frequency-domain analysis: the FEM applied to the scalar wave equation , 2004 .

[28]  Gilles Fraisse,et al.  Development of a simplified and accurate building model based on electrical analogy , 2002 .

[29]  Francesco Borrelli,et al.  Model predictive control of radiant slab systems with evaporative cooling sources , 2015 .

[30]  Kimon A. Antonopoulos,et al.  Numerical solution of unsteady three-dimensional heat transfer during space cooling using ceiling-embedded piping , 1997 .

[31]  Tim Weber,et al.  An optimized RC-network for thermally activated building components , 2005 .

[32]  Dengjia Wang,et al.  Study on heat transfer process for in-slab heating floor , 2012 .

[33]  Dengjia Wang,et al.  Numerical and experimental analysis of floor heat storage and release during an intermittent in-slab floor heating process , 2014 .

[34]  Natale Arcuri,et al.  A new parameter for the dynamic analysis of building walls using the harmonic method , 2015 .

[35]  Zhe Tian,et al.  Establishment and validation of modified star-type RC-network model for concrete core cooling slab , 2011 .

[36]  Xing Jin,et al.  Numerical simulation of radiant floor cooling system: The effects of thermal resistance of pipe and water velocity on the performance , 2010 .

[37]  K. A. Antonopoulos.  Analytical and numerical heat transfer in cooling panels , 1992 .

[38]  Xinhua Xu,et al.  Development of a simplified heat transfer model of hollow blocks by using finite element method in frequency domain , 2016 .

[39]  Viktor Dorer,et al.  Interaction of an air system with concrete core conditioning , 1999 .

[40]  Yu Jiang,et al.  Experimental investigation on a novel temperature and humidity independent control air conditioning system – Part II: Heating condition , 2014 .

[41]  Young Tae Chae,et al.  Thermal performance evaluation of hybrid heat source radiant system using a concentrate tube heat exchanger , 2014 .

[42]  Jianing Zhao,et al.  A new simplified model to calculate surface temperature and heat transfer of radiant floor heating and cooling systems , 2015 .

[43]  Doosam Song,et al.  Performance evaluation of a radiant floor cooling system integrated with dehumidified ventilation , 2008 .

[44]  Fu Xiao,et al.  Active pipe-embedded structures in buildings for utilizing low-grade energy sources: A review , 2010 .

[45]  Viktor Dorer,et al.  Application range of thermally activated building systems tabs , 2007 .

[46]  Jianlei Niu,et al.  Energy savings potential of chilled-ceiling combined with desiccant cooling in hot and humid climates , 2002 .

[47]  J.A.M. Carrer,et al.  On the use of pseudo-forces to consider initial conditions in 3D time- and frequency-domain acoustic analysis , 2006 .

[48]  R. K. Wood,et al.  Simulation of the dynamic behaviour of a hydronic floor heating system , 1995 .

[49]  Lin-Shu Wang,et al.  Modeling of TABS-based thermally manageable buildings in Simulink , 2013 .

[50]  E. Kreyszig,et al.  Advanced Engineering Mathematics. , 1974 .

[51]  Andrzej Górka,et al.  Simulations of floor cooling system capacity , 2013 .