Fault-tolerant control system of flexible arm for sensor fault by using reaction force observer

In recent years, control system reliability has received much attention with increase of situations where computer-controlled systems such as robot control systems are used. In order to improve reliability, control systems need to have abilities to detect a fault (fault detection) and to maintain the stability and the control performance (fault tolerance). In this paper, we address the vibration suppression control of a one-link flexible arm robot. Vibration suppression is realized by an additional feedback of a strain gauge sensor attached to the arm besides motor position. However, a sensor fault (e.g., disconnection) may degrade the control performance and make the control system unstable at its worst. In this paper, we propose a fault-tolerant control system for strain gauge sensor fault. The proposed control system estimates a strain gauge sensor signal based on the reaction force observer and detects the fault by monitoring the estimation error. After fault detection, the proposed control system exchanges the faulty sensor signal for the estimated one and switches to a fault-mode controller so as to maintain the stability and the control performance. We apply the proposed control system to the vibration suppression control system of a one-link flexible arm robot and confirm the effectiveness of the proposed control system by some experiments.

[1]  Kiyoshi Ohishi,et al.  Hybrid Position and Force Control Without Force Sensor , 1996, J. Robotics Mechatronics.

[2]  Arun T. Vemuri,et al.  Sensor bias fault diagnosis in a class of nonlinear systems , 2001, IEEE Trans. Autom. Control..

[3]  Marios M. Polycarpou,et al.  A robust detection and isolation scheme for abrupt and incipient faults in nonlinear systems , 2002, IEEE Trans. Autom. Control..

[4]  B. Pasik-Duncan,et al.  Adaptive Control , 1996, IEEE Control Systems.

[5]  Masaki Yamamoto,et al.  The Estimation of Ambiguous Change in 4WS Control System Using Failure Detection Filter , 1995, J. Robotics Mechatronics.

[6]  Keith Glover,et al.  A loop-shaping design procedure using H/sub infinity / synthesis , 1992 .

[7]  William A. Wolovich,et al.  Bumpless Switching in Hybrid Systems , 1996, Hybrid Systems.

[8]  Karl Johan Åström,et al.  Adaptive Control , 1989, Embedded Digital Control with Microcontrollers.

[9]  Seiichi Shin,et al.  A Design Method for Fault-Tolerant Multivariable Control Systems , 1998 .

[10]  Toshiyuki Murakami,et al.  A Vibration Suppression Control of Flexible Manipulator by Estimated Reaction Torque and Multiple Acceleration Feedback , 1999 .

[11]  Y. Izumikawa,et al.  Vibration suppression control of flexible arm robot by PD gain switching considering sensor failure , 2002, 2002 IEEE International Conference on Industrial Technology, 2002. IEEE ICIT '02..

[12]  T. Bastogne,et al.  A general fault-tolerant control approach: application to a winding machine , 1999, Proceedings of the 38th IEEE Conference on Decision and Control (Cat. No.99CH36304).

[13]  Toshiyuki Murakami,et al.  Vibration Control of a 2 Mass Resonant System by the Resonance Ratio Control , 1993 .

[14]  Rolf Isermann,et al.  Fault-tolerant drive-by-wire systems , 2002 .

[15]  Shigeru Okuma,et al.  Switching of H∞ Controllers under Constraints and Decision of Controller State at Instance of the Controller Switching , 2001 .

[16]  P. Frank,et al.  Fault detection via factorization approach , 1990 .