Development of Efficient High Power Amplifier With More Than an Octave Bandwidth

This paper presents a design of a GaN HEMT-based power amplifier (PA), with enhanced efficiency and linearity over the operation band from 0.5 to 1.5 GHz. The design is based on wideband load-pull and source-pull analysis. A novel procedure is developed to optimize the impedance values and synthesize the matching networks. The amplifier achieves drain efficiency of 40%–68% and power added efficiency (PAE) of 35.7%–63.8%, over the entire frequency band measured for an input power of 24 dBm. To ensure flat gain response, a high pass filter is deployed at the input of the PA, thus achieving a gain of 13.8 ±1 dB for the entire band. Wideband matching circuits are realized on Taconic RF35 with dielectric constant of 3.5 and thickness of 0.76 mm. The PA is found to maintain output power of 36.8–38.3 dBm across the frequency band. Carrier to intermodulation distortion ratio for two-tone input signal with 24-dBm power per-tone and a spacing of 5 MHz is found to be better than 30 dB. In addition, the PA is tested for frequency spacing values of 20 and 25 MHz and good linearity levels are attained. The developed PA thus provides attractive features related to efficiency, linearity, and extended bandwidth, which make this amplifier appropriate for implementations in various wireless communications systems.

[1]  Lee Sangho,et al.  6–18 GHz, 26 W GaN HEMT compact power-combined non-uniform distributed amplifier , 2016 .

[2]  P. Colantonio,et al.  An approach to harmonic load- and source-pull measurements for high-efficiency PA design , 2004, IEEE Transactions on Microwave Theory and Techniques.

[3]  Lei Zhang,et al.  A Linearized 2–3.5 GHz Highly Efficient Harmonic-Tuned Power Amplifier Exploiting Stepped-Impedance Filtering Matching Network , 2014, IEEE Microwave and Wireless Components Letters.

[4]  Songbai He,et al.  Design of Broadband Linear and Efficient Power Amplifier for Long-Term Evolution Applications , 2013, IEEE Microwave and Wireless Components Letters.

[5]  P.I. Richards,et al.  Resistor-Transmission-Line Circuits , 1948, Proceedings of the IRE.

[6]  Paul J. Tasker,et al.  Continuous Mode Power Amplifier Design Using Harmonic Clipping Contours: Theory and Practice , 2014, IEEE Transactions on Microwave Theory and Techniques.

[7]  Kazuyuki Kuroda,et al.  Chapter II - General Properties and Synthesis of Transmission-Line Networks , 1970 .

[8]  A. Kistchinsky.  Ultra-Wideband GaN Power Amplifiers – From Innovative Technology to Standart Products , 2011 .

[9]  E. M. Jones,et al.  Microwave Filters, Impedance-Matching Networks, and Coupling Structures , 1980 .

[10]  Yongle Wu,et al.  A novel dual-band balanced power amplifier using branch-line couplers with four arbitrary terminated resistances , 2015 .

[11]  Jr. R. Wyndrum.  Microwave filters, impedance-matching networks, and coupling structures , 1965 .

[12]  Andrei Grebennikov,et al.  High-Efficiency Class-E Power Amplifier With Shunt Capacitance and Shunt Filter , 2016, IEEE Transactions on Circuits and Systems I: Regular Papers.

[13]  B. Siddik Yarman,et al.  3.5-3.8GHz class-E balanced GaN HEMT power amplifier with 20W Pout and 80% PAE , 2013, IEICE Electron. Express.