Effects of Bi2O3 Doping on the Mechanical Properties of PbO Ceramic Pellets Used in Lead-Cooled Fast Reactors

In this paper, the effects of Bi2O3 doping on the mechanical properties of PbO ceramic pellets were studied. Different ratios of Bi2O3/PbO (i.e., xBi2O3-(1−x) PbO, where x is 0, 1, 3, 5, or 7 wt.%) were fabricated and sintered at 570, 620, and 670 °C. Mechanical properties including density, hardness, flexural strength, and sintering of PbO were studied for each of the aforementioned compositions. Phase composition, microstructure, and the worn surfaces of the composites were characterized by scanning electron microscopy and X-ray diffraction (XRD). The XRD analysis revealed that a solid solution formed in the composite ceramic. The best suited conditions of temperature and doping of Bi2O3 for optimal sintering were found to be 620 °C and 3 wt.%, respectively. The hardness of the 3 wt.% Bi2O3-97 wt.% PbO ceramic was found to be 717 MPa, which is about four times higher than the hardness of pure PbO. In addition, the strength of the composites was found to be 43 MPa, which is two times higher than that of pure PbO. The integrity of the composites was verified using the lead–bismuth eutectic alloy flushing experiment. The results of this research paper are important for future studies of oxygen control in the lead–bismuth eutectic alloy of lead-cooled fast reactors.

[1]  Y. Xu,et al.  Sintering Behavior of Lead Oxide Ceramic Prepared by Microwave Sintering , 2014 .

[2]  C. Schroer,et al.  Oxygen control systems and impurity purification in LBE: Learning from DEMETRA project , 2011 .

[3]  B. S. Murty,et al.  Investigation and characterization of Pb(Zr0.52Ti0.48)O3 nanocrystalline ferroelectric ceramics: By conventional and microwave sintering methods , 2011 .

[4]  Jinsuo Zhang,et al.  Review of the studies on fundamental issues in LBE corrosion , 2008 .

[5]  Minoru Takahashi,et al.  Study on control of oxygen concentration in lead–bismuth flow using lead oxide particles , 2006 .

[6]  J. Rödel,et al.  Evolution of Young's Modulus, Strength, and Microstructure during Liquid‐Phase Sintering , 2005 .

[7]  V. S. Stepanov,et al.  Use of lead-bismuth coolant in nuclear reactors and accelerator-driven systems , 1997 .

[8]  J. B. Clark,et al.  Sintering of PZT Ceramics: I, Atmosphere Control , 1983 .

[9]  S. Vanmaercke,et al.  A mass transfer correlation for packed bed of lead oxide spheres in flowing lead-bismuth eutectic at high Peclet numbers , 2015 .

[10]  P. N. Martynov,et al.  Designing Mass Exchangers for Control of Oxygen Content in Pb-Bi (Pb) Coolants in Various Research Facilities , 2009 .

[11]  R. Hultgren.  Handbook on Lead-bismuth Eutectic Alloy and Lead Properties, Materials Compatibility, Thermal-hydraulics and Technologies , 2007 .

[12]  Lide Zhang,et al.  Influence of molybdenum addition on the microstructure and mechanical properties of TiC-based cermets with nano-TiN modification , 2003 .