Coil-On-Plug Ignition for Oxygen/Methane Liquid Rocket Engines in Thermal-Vacuum Environments

A coil-on-plug ignition system has been developed and tested for Liquid Oxygen (LOX) / liquid methane rocket engines operating in thermal vacuum conditions. The igniters were developed and tested as part of the Integrated Cryogenic Propulsion Test Article (ICPTA), previously tested as part of the Project Morpheus test vehicle. The ICPTA uses an integrated, pressure-fed, cryogenic LOX/methane propulsion system including a reaction control system (RCS) and a main engine. The ICPTA was tested at NASA Glenn Research Center’s Plum Brook Station in the Spacecraft Propulsion Research Facility (B-2) under vacuum and thermal vacuum conditions. In order to successfully demonstrate ignition reliability in the vacuum conditions and eliminate corona discharge issues, a coil-on-plug ignition system has been developed. The ICPTA uses spark-plug ignition for both the main engine igniter and the RCS. The coil-on-plug configuration eliminates the conventional high-voltage spark plug cable by combining the coil and the spark-plug into a single component. Prior to ICPTA testing at Plum Brook, component-level reaction control engine (RCE) and main engine igniter testing was conducted at NASA Johnson Space Center (JSC), which demonstrated successful hot-fire ignition using the coil-on-plug from sea-level ambient conditions down to 10-2 torr. Integrated vehicle hot-fire testing at JSC demonstrated electrical and command/data system performance. Lastly, Plum Brook testing demonstrated successful ignitions at simulated altitude conditions at 30 torr and cold thermal-vacuum conditions at 6 torr. The test campaign successfully proved that coil-onplug technology will enable integrated LOX/methane propulsion systems in future spacecraft.

[1]  Eric A. Hurlbert,et al.  Development and Flight Operation of a 5 lbf to 20 lbf O2/CH4 Roll Control Engine for Project Morpheus , 2014 .

[2]  Rafael Jimenez,et al.  100-Lb(f) LO2/LCH4 Reaction Control Engine Technology Development for Future Space Vehicles , 2010 .

[3]  Eric Hurlbert,et al.  870 lbf Reaction Control System Tests using LO , 2008 .

[4]  Eric Hurlbert,et al.  870lbf Reaction Control System Tests Using LOx/Ethanol and LOx/Methane at White Sands Test Facility , 2008 .

[5]  William M. Marshall,et al.  Hot-Fire Testing of 100 LB(sub F) LOX/LCH4 Reaction Control Engine at Altitude Conditions , 2010 .

[6]  William M. Marshall,et al.  Summary of Altitude Pulse Testing of a 100-lbf L02/LCH4 Reaction Control Engine , 2011 .

[7]  John C. Melcher,et al.  Liquid Oxygen/Liquid Methane Test Results of the RS-18 Lunar Ascent Engine at Simulated Altitude Conditions at NASA White Sands Test Facility , 2009 .

[8]  William M. Marshall,et al.  Experimental Investigation of Augmented Spark Ignition of a LO2/LCH4 Reaction Control Engine at Altitude Conditions , 2012 .

[9]  R. Werlink,et al.  Vehicle-Level Oxygen/Methane Propulsion System Hotfire Testing at Thermal Vacuum Conditions , 2017 .

[10]  E. Hurlbert,et al.  Characterization of a Pressure-Fed LOX/LCH4 Reaction Control System Under Simulated Altitude and Thermal Vacuum Conditions , 2017 .

[11]  Mark D. Klem,et al.  Propulsion Risk Reduction Activities for Non-Toxic Cryogenic Propulsion , 2010 .

[12]  Eric A. Hurlbert,et al.  Sea-Level Flight Demonstration and Altitude Characterization of a LO2/LCH4 Based Accent Propulsion Lander , 2009 .

[13]  William M. Marshall,et al.  Development of Augmented Spark Impinging Igniter System for Methane Engines , 2017 .

[14]  William M. Marshall,et al.  Analysis of 100-lb(sub f) (445-N) LO2-LCH4 Reaction Control Engine Impulse Bit Performance , 2012 .