A case study on energy consumption and overheating for a UK industrial building with rooflights

Rooflights have become the common installations for industrial buildings to meet both the human health requirements for natural light and the need to save artificial lighting energy, especially for retail or distribution sheds that have big roof to floor area ratios and limitations of using glazing on side elevations. Since almost all of these buildings normally operate during daytime, an opportunity exists to save lighting energy by fitting automatic artificial lighting control. However, due to solar gains through the rooflights, the buildings are vulnerable to summer overheating. If overheating occurs regularly or over sustained periods, it will lead to the need for mechanical cooling, which inevitably results in more operational energy consumption in addition to the initial installation cost. To remedy this potential problem, natural ventilation through ridge openings is explored in this paper because it consumes almost no extra operational energy. Thermal modelling is therefore implemented with focus on influences of lighting control on energy consumption and effects of natural ventilation on reducing overheating. The modelling results indicate that lighting control can save lighting energy by 70% and the use of both ridge ventilation and lighting control can reduce overheating hours considerably, as internal heat is dissipated through the ridge openings and lighting heat gains are cut. In addition, converted from lighting and heating energy used, the overall CO2 reduction can reach 45% when both lighting control and ridge ventilation are applied. The findings from the study would encourage the use of rooflights for industrial buildings and would provide guidance on how to save operational energy while ensuring the thermal comfort inside the buildings.

[1]  E. Ne'eman.  A comprehensive approach to the integration of daylight and electric light in buildings , 1984 .

[2]  Henri Juslén,et al.  Mechanisms involved in enhancing human performance by changing the lighting in the industrial workplace , 2005 .

[3]  Konstantinos Papamichael,et al.  A method for simulating the performance of photosensor-based lighting controls , 2002 .

[4]  Åke Blomsterberg,et al.  Energy saving potential and strategies for electric lighting in future North European, low energy office buildings: A literature review , 2011 .

[5]  Dorota Chwieduk,et al.  Recommendation on modelling of solar energy incident on a building envelope , 2009 .

[6]  Anca D. Galasiu,et al.  Impact of window blinds on daylight-linked dimming and automatic on/off lighting controls , 2004 .

[8]  D. Li,et al.  An analysis of measured and simulated daylight illuminance and lighting savings in a daylit corridor , 2005 .

[9]  Gilles Fraisse,et al.  Influence of the coupling between daylight and artificial lighting on thermal loads in office buildings , 2004 .

[10]  M. Newborough,et al.  An approach for estimating the carbon emissions associated with office lighting with a daylight contribution , 2007 .

[11]  Danny H.W. Li,et al.  Evaluation of lighting performance in office buildings with daylighting controls , 2001 .

[12]  C. Y. Chan,et al.  A mini-scale modeling approach to natural daylight utilization in building design , 2007 .

[13]  E. Gratia,et al.  Guidelines for improving natural daytime ventilation in an office building with a double-skin facade , 2007 .

[14]  H. Manz.  Total solar energy transmittance of glass double façades with free convection , 2004 .

[15]  Danny H.W. Li,et al.  Lighting and energy performance for an office using high frequency dimming controls , 2006 .

[16]  M. Atif,et al.  Energy performance of daylight-linked automatic lighting control systems in large atrium spaces: report on two field-monitored case studies , 2003 .

[17]  Christoph F. Reinhart,et al.  Adding advanced behavioural models in whole building energy simulation: A study on the total energy impact of manual and automated lighting control , 2006 .

[18]  A. De Herde,et al.  Overheating and Daylighting in Commercial Buildings , 1994 .

[19]  Jean-Louis Scartezzini,et al.  Minimizing lighting power density in office rooms equipped with Anidolic Daylighting Systems , 2010 .

[20]  Umberto Amato,et al.  Effects of thermal control and of passive solar elements on the dynamic behaviour of a building , 1984 .

[21]  J. F. Nicol,et al.  Suggestion for new approach to overheating diagnostics , 2009 .

[22]  Moncef Krarti,et al.  Assessment of natural and hybrid ventilation models in whole-building energy simulations , 2011 .

[23]  Moncef Krarti,et al.  A simplified method to estimate energy savings of artificial lighting use from daylighting , 2005 .

[24]  Simon Roberts,et al.  Effects of climate change on the built environment , 2008 .

[25]  Magali Bodart,et al.  Lighting energy savings in offices using different control systems and their real consumption , 2008 .

[26]  Paul J. Littlefair,et al.  Photoelectric control: the effectiveness of techniques to reduce switching frequency , 2001 .