EUV actinic blank inspection: from prototype to production

The availability of actinic blank inspection is one of the key milestones for EUV lithography on the way to high volume manufacturing. Placed at the very beginning of the mask manufacturing flow, blank inspection delivers the most critical data set for the judgment of the initial blank quality and final mask performance. From all actinic metrology tools proposed and discussed over the last years, actinic blank inspection (ABI) tool is the first one to reach the pre-production status. In this paper we give an overview of EIDEC-Lasertec ABI program, provide a description of the system and share the most recent performance test results of the tool for 16 nm technology node.

[1]  Soichi Inoue,et al.  EUV actinic blank inspection tool with a high magnification review mode , 2012, Other Conferences.

[2]  Eric Hendrickx,et al.  Evidence of printing blank-related defects on EUV masks missed by blank inspection , 2011, European Mask and Lithography Conference.

[3]  Kazunori Seki,et al.  Shedding light on EUV mask inspection , 2012, Other Conferences.

[4]  Takeshi Yamane,et al.  Development of actinic full-field EUV mask blank inspection tool at MIRAI-Selete , 2009, Advanced Lithography.

[5]  Eric Hendrickx,et al.  Natural EUV mask blank defects: evidence, timely detection, analysis and outlook , 2010, Photomask Technology.

[6]  Hidehiro Watanabe,et al.  Experimental phase defect printability evaluation using a programmed phase defect in EUVL mask , 2013, Advanced Lithography.

[7]  Sungmin Huh,et al.  Printability and inspectability of defects on EUV blank for 2xnm hp HVM application , 2012, Advanced Lithography.

[8]  Masaaki Ito,et al.  Concept of ultra-fast at-wavelength inspection of defects on multilayer mask blanks using a laser-produced plasma source , 2003 .

[9]  Kenneth A. Goldberg,et al.  EUV and non-EUV inspection of reticle defect repair sites , 2007, SPIE Advanced Lithography.

[10]  Eric Hendrickx,et al.  Additional evidence of EUV blank defects first seen by wafer printing , 2011, Photomask Technology.

[11]  Sungmin Huh,et al.  Defect printability comparing actinic printing with advanced simulation for EUV masks , 2013, Advanced Lithography.

[12]  Tsuneo Terasawa,et al.  High-speed actinic EUV mask blank inspection with dark-field imaging , 2004, Photomask Japan.

[13]  Takeshi Yamane,et al.  Actinic EUVL mask blank inspection and phase defect characterization , 2009, Photomask Japan.

[14]  P. Kearney,et al.  Multilayer defects nucleated by substrate pits: a comparison of actinic inspection and non-actinic inspection techniques , 2006, SPIE Photomask Technology.

[15]  Andrew Cross,et al.  Investigation of the performance of state-of-the-art defect inspection tools within EUV lithography , 2012, Advanced Lithography.