CFD Modeling of Methane Autothermal Reforming in a Catalytic Microreactor

Producing hydrogen from natural gas for a mini scale fuel cell is a new challenge for researchers. Therefore, modeling of hydrogen production microreactors should be helpful for designing and developing new microreactors. Experimental sensing of velocity, concentration, temperature and reaction rates in numerous points of the microreactor is impracticable. A microreactor in special geometry was considered for hydrogen production and a CFD model was developed in order to incorporate the mechanism of autothermal reforming. This mechanism includes three main reactions and Langmuir-Hinshelwood type kinetic rates. A three dimensional reformer model was developed to simulate the reactive laminar flow model of this microreactor. Effects of styles of feed entrance, air to fuel ratio and adding water to methane were studied. This model shows that there are hot spots near the entrance of the microreactor where the total oxidation of methane occurs and air distribution along the microreactor is a good solution for hot spot problems. The model shows that air distribution is good for fuel cell application because of high hydrogen production and low CO content in the outlet.

[1]  S. Chan,et al.  Modeling of a catalytic autothermal methane reformer for fuel cell applications , 2004 .

[2]  O. Deutschmann,et al.  Rational modeling of the CPO of methane over platinum gauze: Elementary gas-phase and surface mechanisms coupled with flow simulations , 2007 .

[3]  S. Chan,et al.  Hydrogen production for fuel cells by autothermal reforming of methane over sulfide nickel catalyst on a gamma alumina support , 2006 .

[4]  David L. Trimm,et al.  The combustion of methane on platinum—alumina fibre catalysts—I: Kinetics and mechanism , 1980 .

[5]  David L. Trimm,et al.  The design and testing of an autothermal reactor for the conversion of light hydrocarbons to hydrogen I. The kinetics of the catalytic oxidation of light hydrocarbons , 1996 .

[6]  G. Marin,et al.  An experimental reactor to study the intrinsic kinetics of catalytic partial oxidation of methane in the presence of heat-transport limitations , 1999 .

[7]  Krzysztof Gosiewski,et al.  Effect of the intraparticle mass transport limitations on temperature profiles and catalytic performance of the reverse-flow reactor for the partial oxidation of methane to synthesis gas , 1999 .

[8]  S. Chan,et al.  Transient performance of an autothermal reformer—A 2-D modeling approach , 2005 .

[9]  Marie-Françoise Reyniers,et al.  Catalytic Partial Oxidation. Part I. Catalytic Processes to Convert Methane: Partial or Total Oxidation , 2002 .

[10]  G. Froment,et al.  Methane steam reforming, methanation and water‐gas shift: I. Intrinsic kinetics , 1989 .