Aeroelastic flutter energy harvester design: the sensitivity of the driving instability to system parameters

This study examines the design parameters affecting the stability characteristics of a novel fluid flow energy harvesting device powered by aeroelastic flutter vibrations. The energy harvester makes use of a modal convergence flutter instability to generate limit cycle bending oscillations of a cantilevered piezoelectric beam with a small flap connected to its free end by a revolute joint. The critical flow speed at which destabilizing aerodynamic effects cause self-excited vibrations of the structure to emerge is essential to the design of the energy harvester because it sets the lower bound on the operating wind speed and frequency range of the system. A linearized analytic model of the device that accounts for the three-way coupling between the structural, unsteady aerodynamic, and electrical aspects of the system is used to examine tuning several design parameters while the size of the system is held fixed. The effects on the aeroelastic system dynamics and relative sensitivity of the flutter stability boundary are presented and discussed. A wind tunnel experiment is performed to validate the model predictions for the most significant system parameters.

[1]  Dustin Lee Morris,et al.  Wind generated electricity using flexible piezoelectric materials. , 2010 .

[2]  Jan M. Rabaey,et al.  A study of low level vibrations as a power source for wireless sensor nodes , 2003, Comput. Commun..

[3]  Z. J. Wang,et al.  Unsteady aerodynamics of fluttering and tumbling plates , 2005, Journal of Fluid Mechanics.

[4]  Ephrahim Garcia,et al.  Beam Shape Optimization for Power Harvesting , 2010 .

[5]  Matthew Bryant,et al.  Modeling and Testing of a Novel Aeroelastic Flutter Energy Harvester , 2011 .

[6]  D. Guyomar,et al.  Toward energy harvesting using active materials and conversion improvement by nonlinear processing , 2005, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[7]  C. Williamson,et al.  MOTIONS, FORCES AND MODE TRANSITIONS IN VORTEX-INDUCED VIBRATIONS AT LOW MASS-DAMPING , 1999 .

[8]  Joseph R. Burns,et al.  The Energy Harvesting Eel: a small subsurface ocean/river power generator , 2001 .

[9]  Henry A. Sodano,et al.  A review of power harvesting using piezoelectric materials (2003–2006) , 2007 .

[10]  Dewey H. Hodges,et al.  Introduction to Structural Dynamics and Aeroelasticity: Contents , 2002 .

[11]  B. W. van Oudheusden.  Rotational one-degree-of-freedom galloping in the presence of viscous and frictional damping , 1996 .

[12]  Norbert Schwesinger,et al.  A Novel Hydropower Harvesting Device , 2004 .

[13]  Ephrahim Garcia,et al.  Power Optimization of Vibration Energy Harvesters Utilizing Passive and Active Circuits , 2010 .

[14]  D. Peters,et al.  Finite state induced flow models. I - Two-dimensional thin airfoil , 1995 .

[15]  A. Smits,et al.  Energy harvesting eel , 2001 .

[16]  Nesbitt W. Hagood,et al.  Modelling of Piezoelectric Actuator Dynamics for Active Structural Control , 1990 .

[17]  Daniel J. Inman,et al.  Estimation of Electric Charge Output for Piezoelectric Energy Harvesting , 2004 .

[18]  Soon-Duck Kwon,et al.  A T-shaped piezoelectric cantilever for fluid energy harvesting , 2010 .