论文信息 - Mechanics of Oblique Machining: Predicting Chip Geometry and Cutting Forces from Work Material Properties and Cutting Conditions

Mechanics of Oblique Machining: Predicting Chip Geometry and Cutting Forces from Work Material Properties and Cutting Conditions

A recently developed theory of orthogonal machining is used to calculate chip geometry (including tool-chip contact length) and cutting forces for SAE 1112 steel over a wide range of cutting conditions. A comparison with experimental results shows excellent agreement for most of the cutting conditions considered.

P. Oxley | P. L. B. Oxley | R. G. Fenton | R. Fenton

[1] G. V. Stabler. The Fundamental Geometry of Cutting Tools , 1951 .

[2] J. D. Campbell,et al. The temperature and strain-rate dependence of the shear strength of mild steel , 1970 .

[3] S. K. Samanta. Resistance to dynamic compression of low-carbon steel and alloy steels at elevated temperatures and at high strain-rates , 1968 .

[4] T. Hsu,et al. An analysis of the plastic deformation due to orthogonal and oblique cutting , 1966 .

[5] M. E. Merchant. Mechanics of the Metal Cutting Process. I. Orthogonal Cutting and a Type 2 Chip , 1945 .

[6] E.J.A. Armarego,et al. Oblique machining with a single cutting edge , 1964 .

[7] P. Oxley,et al. An Experimental Investigation of the Influence of Speed and Scale on the Strain-Rate in a Zone of Intense Plastic Deformation , 1969 .

[8] P. Oxley,et al. An Experimental Investigation of the Influence of Strain-Rate and Temperature on the Flow Stress Properties of a Low Carbon Steel Using a Machining Test: , 1970 .

[9] A C Rapier,et al. A theoretical investigation of the temperature distribution in the metal cutting process , 1954 .

[10] H. E. Enahoro,et al. Flow along Tool-Chip Interface in Orthogonal Metal Cutting , 1966 .

[11] W. B. Palmer,et al. Mechanics of Orthogonal Machining , 1959 .

[12] P. Oxley,et al. Mechanics of Orthogonal Machining: Allowing for the Effects of Strain Rate and Temperature on Tool-Chip Friction , 1968 .