Effect of the geometry of a working electrode on the behavior of a planar amperometric NO2 sensor based on solid polymer electrolyte

Abstract An amperometric NO 2 sensor with a new type of solid polymer electrolyte (SPE) and a glassy carbon working electrode is presented. The electrolyte is based on 1-ethyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide [C 2 mim][NTf 2 ] ionic liquid immobilized in poly(vinylidene fluoride) matrix [PVDF]. The analyte, gaseous nitrogen dioxide, was detected by reduction at −500 mV vs. a platinum pseudoreference electrode. The sensor exhibited a linear behavior in the whole tested range, i.e., 0–10 ppm, and its sensitivity was 0.66 × 10 −6  A/ppm. The rise/recovery times were of the order of tens of seconds. In addition, the influence of the geometry (area and thickness) of the carbon working electrode on sensor response during short-term and long-term exposure to nitrogen dioxide was investigated. The area of the working electrode strongly influenced the stability and noise of the sensor: the smaller the electrode area, the better the stability of the sensor and the lower the noise level. The response times were influenced by the thickness of the carbon working electrode: the thicker the electrode, the longer the response time. It was also demonstrated that glassy carbon is a good candidate for the preparation of the working electrode. The use of a platinum pseudoreference electrode simplifies sensor fabrication and does not have any negative effect on sensor stability.

[1]  Susumu Nakamaya.  Potentiometric NO2 gas sensor using LiRESiO4 (RE=Nd and Sm) , 2001 .

[2]  S. Nespurek,et al.  Interaction of nitrogen dioxide with sulfonamide-substituted phthalocyanines: Towards NO2 gas sensor , 2012 .

[3]  J. Reiter,et al.  A planar, solid-state amperometric sensor for nitrogen dioxide, employing an ionic liquid electrolyte contained in a polymeric matrix , 2012 .

[4]  Andreas Hierlemann,et al.  Wafer-level flame-spray-pyrolysis deposition of gas-sensitive layers on microsensors , 2008 .

[5]  Monika Tomar,et al.  SnO2 thin film sensor with enhanced response for NO2 gas at lower temperatures , 2011 .

[6]  M. Zolfigol,et al.  Advances in the application of N2O4/NO2 in organic reactions , 2010 .

[7]  H. Ohno.  Importance and Possibility of Ionic Liquids , 2005 .

[8]  Karel Štulík,et al.  Electrochemical sensors with solid polymer electrolytes , 1999 .

[9]  Bruno Scrosati,et al.  Ionic-liquid materials for the electrochemical challenges of the future. , 2009, Nature materials.

[10]  F. Opekar,et al.  Amperometric solid-state NO2 sensor based on plasticized PVC matrix containing a hydrophobic electrolyte , 1997 .

[11]  S. Alm,et al.  Personally measured weekly exposure to NO2 and respiratory health among preschool children. , 1999, The European respiratory journal.

[12]  Zev Ross,et al.  Nitrogen dioxide prediction in Southern California using land use regression modeling: potential for environmental health analyses , 2006, Journal of Exposure Science and Environmental Epidemiology.

[13]  A. Teleki,et al.  Semiconductor gas sensors: dry synthesis and application. , 2010, Angewandte Chemie.

[14]  C. Leygraf,et al.  In Situ Studies of the Initial Atmospheric Corrosion of Copper Influence of Humidity, Sulfur Dioxide, Ozone, and Nitrogen Dioxide , 2000 .

[16]  Luca Ottaviano,et al.  NO2 response to few-layers MoS2 , 2012 .

[17]  G. Scollary,et al.  A statistical overview of standard (IUPAC and ACS) and new procedures for determining the limits of detection and quantification: Application to voltammetric and stripping techniques (Technical Report) , 1997 .

[18]  R. A. Collins,et al.  A study of the interaction between nitrogen dioxide and lead phthalocyanine using electrical conduction and optical absorption , 1997 .

[19]  Sébastien Candel,et al.  Combustion control and sensors: a review , 2002 .

[20]  M. Grätzel,et al.  Hydrophobic, Highly Conductive Ambient-Temperature Molten Salts. , 1996, Inorganic chemistry.

[21]  J. Reiter,et al.  Ionic liquid―polymer electrolyte for amperometric solid-state NO2 sensor , 2011 .

[22]  C. Glorieux,et al.  Temperature dependence of the electrical conductivity of imidazolium ionic liquids. , 2008, The Journal of chemical physics.

[23]  A. Hayashi,et al.  Physical Chemistry of Ionic Liquids, Inorganic and Organic, Protic and Aprotic , 2005 .

[24]  Peter Händel,et al.  Adsorption–desorption noise in QCM gas sensors , 2012 .

[25]  J. Do,et al.  Amperometric nitrogen dioxide gas sensor: preparation of PAn/Au/SPE and sensing behaviour , 2001 .

[26]  Karel Štulík,et al.  An amperometric solid-state NO2 sensor with a solid polymer electrolyte and a reticulated vitreous carbon indicator electrode , 2000 .

[27]  T. Vogt,et al.  Highly sensitive and multidimensional detection of NO2 using In2O3 thin films , 2011 .

[28]  K. Ho,et al.  Electrochemical reduction of NO2 at a Pt/membrane electrode-Application to amperometric NO2 sensing , 2009 .

[29]  J. Simon,et al.  METALLOPHTHALOCYANINES. GAS SENSORS, RESISTORS AND FIELD EFFECT TRANSISTORS , 1998 .

[30]  M. Henry,et al.  Chronic toxicity of nitrogen dioxide. I. Effect on resistance to bacterial pneumonia. , 1968, Archives of environmental health.

[31]  F. Opekar,et al.  Au/PVC composite—a new material for solid-state gas sensors: Detection of nitrogen dioxide in the air , 2004 .

[32]  Effect of gas humidity on the potential of pseudoreference Pt/air electrode in amperometric solid-state gas sensors , 2002 .

[33]  T. Vandernoot,et al.  Temperature dependence of viscosity for room temperature ionic liquids , 2004 .

[34]  Joseph R. Stetter,et al.  Microfabricated amperometric gas sensors , 1988 .