EXPERIMENTAL AND NUMERICAL ASSESSMENT OF A LAST STAGE ST BLADE DAMPING AT LOW LOAD OPERATION
暂无分享,去创建一个
Lorenzo Pinelli | Zdeněk Kubín | Andrea Bessone | Luigi Carassale | Roberto Guida | Antonio Alfio Lo Balbo | Michela Marrè Brunenghi | R. Guida | L. Carassale | L. Pinelli | M. Brunenghi | Z. Kubín | A. Bessone | Antonio Alfio Lo Balbo
[1] Michele Marconcini,et al. Numerical Investigation of Three-Dimensional Clocking Effects in a Low Pressure Turbine , 2004 .
[2] David Bell,et al. Identification of the Stability Margin Between Safe Operation and the Onset of Blade Flutter , 2007 .
[3] Stéphane Mallat,et al. A Wavelet Tour of Signal Processing - The Sparse Way, 3rd Edition , 2008 .
[4] Andrea Arnone,et al. A Time-Accurate 3D Method for Turbomachinery Blade Flutter Analysis , 2009 .
[5] Markus May,et al. Numerical flutter analysis of turbomachinery bladings based on time-linearized, time-spectral and time-accurate simulations , 2011 .
[6] Andrea Arnone,et al. AEROELASTIC STABILITY ANALYSIS OF A NON-ROTATING ANNULAR TURBINE TEST RIG: A COMPARISON BETWEEN A LINEARIZED AND A NON-LINEAR COMPUTATIONAL METHOD , 2015 .
[7] Luigi Carassale,et al. Estimation of Damping for Turbine Blades in Non-Stationary Working Conditions , 2015 .
[8] Luigi Carassale,et al. Modal Identification of Dynamically Coupled Bladed Disks in Run-Up Tests , 2016 .
[9] Milan Petrovic,et al. Part Load Behavior of the LP Part of an Industrial Gas Turbine , 2017 .
[10] Paul Petrie-Repar,et al. Investigation of tip clearance flow effects on an open 3D steam turbine flutter test case , 2017 .
[11] Andrea Arnone,et al. Aeroelastic Investigation of Turbine Blade Assemblies: Cluster System and Mistuned Rows , 2017 .
[12] Damian M. Vogt,et al. On the Impact of Simulation Approaches on the Predicted Aerodynamic Damping of a Low Pressure Steam Turbine Rotor , 2017 .
[13] Luigi Carassale,et al. Wavelet-based identification of rotor blades in passage-through-resonance tests , 2018 .
[14] Christian Frey,et al. Comparison of Linear and Nonlinear Frequency Domain Methods for Flutter Analysis , 2018 .
[15] Enrico Puppo,et al. Aeroelastic Optimization of an Industrial Compressor Rotor Blade Geometry , 2018, Volume 2D: Turbomachinery.