Incipient damage detection and its propagation monitoring of rolling contact fatigue by acoustic emission

The acoustic emission (AE) technique was applied to rolling contact fatigue tests using a test-rig running under constant load and speed for detecting the incipient damage and damage location. This incipiently-damaged roller was investigated in detail and monitored by further running to determine the damage severity and to understand the surface damage propagation process by applying the AE techniques. The conventional AE parameters and AE signal features were studied, and their relation with the AE source locator hit count rate were correlated. The results demonstrated the successful use of the AE measurement unit, which is principally, consists of the AE data analyzer and the AE source locator as a new system for detecting incipient damage produced by fatigue. Moreover, the system is able to forecast the position of the damage in the roller, capable of providing an indication of the severity of damage i.e. damage size, and thus it could allow the user to monitor the rate of further degradation of the rolling elements.

[1]  B. Hamrock.  Ball bearing lubrication , 1981 .

[2]  N. Tandon,et al.  A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearings , 1999 .

[3]  Thomas R. Kurfess,et al.  Rolling element bearing diagnostics in run-to-failure lifetime testing , 2001 .

[4]  P. Andersson,et al.  Acoustic emission of rolling bearings lubricated with contaminated grease , 2000 .

[5]  Steven Y. Liang,et al.  BEARING CONDITION DIAGNOSTICS VIA VIBRATION AND ACOUSTIC EMISSION MEASUREMENTS , 1997 .

[6]  N. Tandon,et al.  Application of acoustic emission technique for the detection of defects in rolling element bearings , 2000 .

[7]  N. Tandon,et al.  Detection of defects in gears by acoustic emission measurements , 1999 .

[8]  David Dornfeld,et al.  Experimental studies of sliding friction and wear via acoustic emission signal analysis , 1990 .

[9]  E. Siores,et al.  Condition monitoring of a gear box using acoustic emission testing , 1997 .

[10]  David,et al.  A comparative experimental study on the use of acoustic emission and vibration analysis for bearing defect identification and estimation of defect size , 2006 .

[11]  David,et al.  Application of acoustic emission to seeded gear fault detection , 2005 .

[12]  Takashi Yamamoto,et al.  A Study on Incipient Damage Monitoring in Rolling Contact Fatigue Process Using Acoustic Emission , 2008 .

[13]  T. Fujiwara,et al.  Paper II(i) Measurement of propagation initiation and propagation time of rolling contact fatigue cracks by observation of acoustic emission and vibration , 1987 .

[14]  Leonard M. Rogers.  Detection of Incipient Damage in Large Rolling Element Bearings , 2006 .

[15]  Takeo Yoshioka,et al.  Diagnosis of Rolling Bearing by Measuring Time Interval of AE Generation , 1999 .

[16]  Sandeep M. Vijayakar,et al.  Detecting Gear Tooth Breakage Using Acoustic Emission: a Feasibility and Sensor Placement Study , 1999 .

[17]  David,et al.  Identification of the acoustic emission source during a comparative study on diagnosis of a spur gearbox , 2005 .

[18]  David Mba,et al.  Development of Acoustic Emission Technology for Condition Monitoring andDiagnosis of Rotating Machines; Bearings, Pumps, Gearboxes, Engines and RotatingStructures. , 2006 .

[19]  P. K. Pearson,et al.  Surface-initiated spalling fatigue in M-50 and M-50 NiL bearings , 1991 .