Fire Experiments and Simulations in a Full-scale Atrium Under Transient and Asymmetric Venting Conditions

An experimental and numerical comparison of new full-scale atrium fire tests in the 20 m cubic atrium with four different heat release rates (1.7 MW, 2.3 MW, 3.9 MW and 5.3 MW) is presented. Different exhaust conditions (steady and transient extraction rates) and different make-up air configurations (symmetric and asymmetric) are assessed. Temperature measurements in the near (fire plume) and far field (close to the walls) have been recorded by means of 59 thermocouples. The smoke layer interface is also estimated by means of a thermocouple tree with 28 measurements using the least-square and the n-percent methods. The simulations have been conducted using FDS (version 6, Release Candidate 3). The comparison with the simulations shows average discrepancies lower than 32% and 11%, for the near and far field temperatures, respectively. A discrepancy lower than 5% (1 m) is obtained by both methods for the smoke layer height when the steady state is reached. Finally, a slower response to an increment on the exhaust rate is predicted on the smoke layer, being more perceptible for high heat release rates.

[1]  James G. Quintiere,et al.  An Assessment of Fire Induced Flows in Compartments , 1984 .

[2]  George Hadjisophocleous,et al.  Large-scale physical model studies for an atrium smoke exhaust system , 1999 .

[3]  Kevin B. McGrattan,et al.  Fire Dynamics Simulator (Version 5): User's Guide , 2007 .

[4]  Bart Merci,et al.  Application of FDS to Adhered Spill Plumes in Atria , 2008 .

[5]  Hao C. Tran,et al.  Data Reduction of Room Tests for Zone Model Validation , 1992 .

[6]  Wan Ki Chow,et al.  A simple two-layer zone model on mechanical exhaust in an atrium , 2005 .

[7]  Yaping He,et al.  Determination of interface height from measured parameter profile in enclosure fire experiment , 1998 .

[8]  Jian Zhou.  Evaluation of atrium smoke exhaust make-up air velocity , 2007 .

[9]  Guillermo Rein,et al.  Experimental data and numerical modelling of 1.3 and 2.3 MW fires in a 20 m cubic atrium , 2009 .

[10]  Kevin B. McGrattan,et al.  Fire dynamics simulator (ver-sion 3) technical reference guide , 2001 .

[11]  Cándido Gutiérrez Montes,et al.  Influence of atrium roof geometries on the numerical predictions of fire tests under natural ventilation conditions , 2013 .

[12]  C. Gutiérrez-Montes,et al.  Numerical model and validation experiments of atrium enclosure fire in a new fire test facility , 2008 .

[13]  Wan Ki Chow,et al.  Experimental Studies on Mechanical Smoke Exhaust System in an Atrium , 2005 .

[14]  C. Gutiérrez-Montes,et al.  Influence of different make-up air configurations on the fire-induced conditions in an atrium , 2010 .

[15]  Steven Verstockt,et al.  Prediction of smoke filling in large volumes by means of data assimilation–based numerical simulations , 2012 .

[16]  Allan Jowsey,et al.  BRE large compartment fire tests - characterising post-flashover fires for model validation , 2007 .

[17]  P. Eng.,et al.  Investigation of Atrium Smoke Exhaust Effectiveness , 1997 .

[18]  Glenn P. Forney,et al.  Fire Dynamics Simulator (Version 2) -- Technical Reference Guide | NIST , 2001 .

[19]  Joseph A. Schetz,et al.  Turbulent Shear Layers in Supersonic Flow , 1998 .

[20]  C. Gutiérrez-Montes,et al.  On the fluid dynamics of the make-up inlet air and the prediction of anomalous fire dynamics in a large-scale facility , 2012 .

[21]  Linda G. Blevins,et al.  Modeling of bare and aspirated thermocouples in compartment fires , 1999 .

[22]  Jose L. Torero,et al.  SFPE handbook of fire protection engineering , 2016 .

[23]  Gary F. Bennett,et al.  The SFPE handbook of fire protection engineering : By P.J. DiNenno, C.L. Beyler, R.L.P. Custer, W.D. Walton and J.M. Watts, Jr., National Fire Protection Association, Quincy, MA and Society of Fire Prot , 1990 .

[25]  Kevin B. McGrattan,et al.  Fire dynamics simulator (version 4) :: user's guide , 2004 .

[26]  James A. Milke,et al.  Using FDS to Simulate Smoke Layer Interface Height in a Simple Atrium , 2007 .

[27]  Glenn P. Forney,et al.  Fire Dynamics Simulator Version 6: Complex Geometry, Embedded Meshes, and Quality Assessment | NIST , 2010 .

[28]  L. Y. Cooper,et al.  An Experimental Study of Upper Hot Layer Stratification in Full-Scale Multiroom Fire Scenarios , 1982 .