Fabrication of Lotus-type Porous Ni3Al Intermetallics

[1]  H. Nakajima,et al.  Effect of solidification velocity on pore morphology of lotus-type porous copper fabricated by unidirectional solidification , 2003 .

[2]  H. Nakajima,et al.  Anisotropic compressive properties of porous copper produced by unidirectional solidification , 2003 .

[3]  John Banhart,et al.  On the Road Again: Metal Foams Find Favor , 2002 .

[4]  H. Nakajima,et al.  Fabrication of Porous Iron by Unidirectional Solidification in Nitrogen Atmosphere , 2002 .

[5]  T. Hirano,et al.  Fabrication of thin foils of binary Ni–Al γ/γ′ two-phase alloys by cold rolling , 2002 .

[6]  K. Murakami,et al.  Evaluation of porosity in porous copper fabricated by unidirectional solidification under pressurized hydrogen , 2001 .

[7]  K. Murakami,et al.  Anisotropic mechanical properties of porous copper fabricated by unidirectional solidification , 2001 .

[8]  K. Murakami,et al.  Fabrication of porous copper by unidirectional solidification under hydrogen and its properties , 2001 .

[9]  中嶋 英雄.  ロータス形状ポーラスメタルの創製 (特集 「界面」と「ナノ」をキーワードに--大阪大学産業科学研究所材料系特集(上)) , 1999 .

[10]  T. Hirano,et al.  Improvement of Room Temperature Ductility of Stoichiometric Ni3Al by Unidirectional Solidification , 1990 .

[11]  H. Inui,et al.  High-temperature structural intermetallics , 2000 .

[12]  Seetharama C. Deevi,et al.  Nickel and iron aluminides: an overview on properties, processing, and applications , 1996 .