Aeromechanics Analysis of a Boundary Layer Ingesting Fan

Abstract Boundary layer ingesting propulsion systems have the potential to significantly reduce fuel burn but these systems must overcome the challenges related to aeromechanics—fan flutter stability and forced response dynamic stresses. High-fidelity computational analysis of the fan aeromechanics is integral to the ongoing effort to design a boundary layer ingesting inlet and fan for fabrication and wind-tunnel test. A three-dimensional, time-accurate, Reynolds-averaged Navier Stokes computational fluid dynamics code is used to study aerothermodynamic and aeromechanical behavior of the fan in response to both clean and distorted inflows. The computational aeromechanics analyses performed in this study show an intermediate design iteration of the fan to be flutter-free at the design conditions analyzed with both clean and distorted in-flows. Dynamic stresses from forced response have been calculated for the design rotational speed. Additional work is ongoing to expand the analyses to off-design conditions, and for on-resonance conditions.

[1]  George L. Stefko,et al.  Comparisons of Flutter Analyses for an Experimental Fan , 2010 .

[2]  Tom Hynes,et al.  Performance of a Boundary Layer Ingesting (BLI) propulsion system , 2007 .

[3]  Gregory Tillman,et al.  Aircraft System Study of Boundary Layer Ingesting Propulsion , 2012 .

[4]  Gregory P. Herrick.  Effects of Inlet Distortion on Aeromechanical Stability of a Forward-Swept High-Speed Fan , 2013 .

[5]  Razvan Virgil Florea,et al.  Parametric Analysis and Design for Embedded Engine Inlets , 2012 .

[6]  Theo G. Keith,et al.  Calculation and Correlation of the Unsteady Flowfield in a High Pressure Turbine , 2002 .

[7]  Theo G. Keith,et al.  Numerical Simulation of Aerodynamic Damping for Flutter Analysis of Turbomachinery Blade Rows , 2003 .

[8]  Kivanc Ekici,et al.  Nonlinear Frequency-Domain Analysis of Unsteady Flows in Turbomachinery with Multiple Excitation Frequencies , 2006 .

[9]  H. D. Li,et al.  Single-Passage Analysis of Unsteady Flows Around Vibrating Blades of a Transonic Fan Under Inlet Distortion , 2002 .

[10]  Jeffrey P. Thomas,et al.  Blade Excitation by Aerodynamic Instabilities: A Compressor Blade Study , 2003 .

[11]  Craig L. Nickol,et al.  Hybrid Wing Body Configuration System Studies , 2009 .

[12]  Theo G. Keith,et al.  Flutter Analysis of a Transonic Fan , 2002 .

[13]  Douglas C. Rabe,et al.  Experimental and Numerical Study of Stall Flutter in a Transonic Low-Aspect Ratio Fan Blisk , 2003 .

[14]  Craig L. Nickol.  Silent Aircraft Initiative Concept Risk Assessment , 2008 .

[15]  J. Smith,et al.  Wake ingestion propulsion benefit , 1991 .

[16]  David L. Daggett,et al.  Blended Wing Body Systems Studies: Boundary Layer Ingestion Inlets with Active Flow Control , 2013 .

[17]  F. O. Carta,et al.  Coupled Blade-Disk-Shroud Flutter Instabilities in Turbojet Engine Rotors , 1967 .

[18]  Abdulnaser I. Sayma,et al.  Computational Study of Intake Duct Effects on Fan Flutter Stability , 2002 .

[19]  Leonel Serrano,et al.  Blended Wing Body (Bwb) Boundary Layer Ingestion (Bli) Inlet Configuration and System Studies , 2013 .

[20]  Melissa B. Carter,et al.  High Reynolds Number Investigation of a Flush-Mounted, S-Duct Inlet with Large Amounts of Boundary Layer Ingestion , 2013 .

[21]  David L. Whitfield,et al.  Navier-Stokes calculations for the unsteady flowfield of turbomachinery , 1993 .

[22]  J. P. Chen,et al.  A Parallel Flow Solver for Unsteady Multiple Blade Row Turbomachinery Simulations , 2001 .