Online Bearing Clearance Monitoring Based on an Accurate Vibration Analysis

Accurate diagnosis of incipient faults in wind turbine (WT) assets will provide sufficient lead time to apply an optimal maintenance for the expensive WT assets which often are located in a remote and harsh environment and their maintenance usually needs heavy equipment and highly skilled engineers. This paper presents an online bearing clearance monitoring approach to diagnose the change of bearing clearance, providing an early and interpretable indication of bearing health conditions. A novel dynamic load distribution method is developed to efficiently gain the general characteristics of vibration response of bearings without local defects but with small geometric errors. It shows that the ball pass frequency of outer race (BPFO) is the primary exciting source due to biased load distribution relating to bearing clearance. The geometric errors, including various orders of runouts on different bearing parts, can be the secondary excitation source. Both sources lead to compound modulation responses with very low amplitudes, being more than 20 dB lower than that of a small local defect on raceways and often buried by background noise. Then, Modulation Signal Bispectrum (MSB) is identified to purify the noisy signal and Gini index is introduced to represent the peakness of MSB results, thereby an interpretable indicator bounded between 0 and 1 is established to show bearing clearance status. Datasets from both a dedicated bearing test and a run-to-failure gearbox test are employed to verify the performance and reliability of the proposed approach. Results show that the proposed method is capable to indicate a change of about 20 µm in bearing clearance online, which provides a significantly long lead time compared to the diagnosis method that focuses only on local defects. Therefore, this method provides a big opportunity to implement more cost-effective maintenance works or carry out timely remedial actions to prolong the lifespan of bearings. Obviously, it is applicable to not only WT assets, but also most rotating machines.

[1]  Yaguo Lei,et al.  A new approach to intelligent fault diagnosis of rotating machinery , 2008, Expert Syst. Appl..

[2]  Tomasz Barszcz,et al.  A novel method for the optimal band selection for vibration signal demodulation and comparison with the Kurtogram , 2011 .

[3]  Yonghao Miao,et al.  Improvement of kurtosis-guided-grams via Gini index for bearing fault feature identification , 2017 .

[4]  Jari Halme,et al.  Rolling contact fatigue and wear fundamentals for rolling bearing diagnostics - state of the art , 2010 .

[5]  Qinkai Han,et al.  Vibration based condition monitoring and fault diagnosis of wind turbine planetary gearbox: A review , 2019, Mechanical Systems and Signal Processing.

[6]  Jishun Li,et al.  Prediction Method for the Radial Runout of Inner Ring in Cylindrical Roller Bearings , 2017 .

[7]  Alessandro Fasana,et al.  The Autogram: An effective approach for selecting the optimal demodulation band in rolling element bearings diagnosis , 2018 .

[8]  Andrew Ball,et al.  A Performance Evaluation of Two Bispectrum Analysis Methods Applied to Electrical Current Signals for Monitoring Induction Motor-Driven Systems , 2019 .

[9]  Wilson Wang,et al.  A Morphological Hilbert-Huang Transform Technique for Bearing Fault Detection , 2016, IEEE Transactions on Instrumentation and Measurement.

[10]  Mehdi Behzad,et al.  A new method for detection of rolling bearing faults based on the Local Curve Roughness approach , 2011 .

[11]  F. Gu,et al.  Extraction of the largest amplitude impact transients for diagnosing rolling element defects in bearings , 2019, Mechanical Systems and Signal Processing.

[12]  Weidong Cheng,et al.  Compound faults detection of rolling element bearing based on the generalized demodulation algorithm under time-varying rotational speed , 2016 .

[13]  Hyun-Chool Shin,et al.  Spectral Gini Index for Quantifying the Depth of Consciousness , 2016, Comput. Intell. Neurosci..

[14]  J. Antoni.  Fast computation of the kurtogram for the detection of transient faults , 2007 .

[15]  Jun Yu,et al.  Planetary gear fault diagnosis using stacked denoising autoencoder and gated recurrent unit neural network under noisy environment and time-varying rotational speed conditions , 2019, Measurement Science and Technology.

[16]  Robert X. Gao,et al.  An integrated fault diagnosis and prognosis approach for predictive maintenance of wind turbine bearing with limited samples , 2020 .

[17]  H.A. Toliyat,et al.  Condition Monitoring and Fault Diagnosis of Electrical Motors—A Review , 2005, IEEE Transactions on Energy Conversion.

[18]  Minping Jia,et al.  A novel weak fault signal detection approach for a rolling bearing using variational mode decomposition and phase space parallel factor analysis , 2019, Measurement Science and Technology.

[19]  Roy Billinton,et al.  Determination of the optimum site-matching wind turbine using risk-based capacity benefit factors , 1999 .

[20]  R. Randall,et al.  OPTIMISATION OF BEARING DIAGNOSTIC TECHNIQUES USING SIMULATED AND ACTUAL BEARING FAULT SIGNALS , 2000 .

[21]  Nadège Bouchonneau,et al.  A review of wind turbine bearing condition monitoring: State of the art and challenges , 2016 .

[22]  Andrew Ball,et al.  Fault feature extraction for rolling element bearing diagnosis based on a multi-stage noise reduction method , 2019, Measurement.

[23]  Robert B. Randall,et al.  Simulating gear and bearing interactions in the presence of faults. Part I. The combined gear bearing dynamic model and the simulation of localised bearing faults , 2008 .

[24]  Fengshou Gu,et al.  A robust detector for rolling element bearing condition monitoring based on the modulation signal bispectrum , 2016 .

[25]  K. Loparo,et al.  Online tracking of bearing wear using wavelet packet decomposition and probabilistic modeling : A method for bearing prognostics , 2007 .

[26]  Anca Daniela Hansen,et al.  Wind turbine concept market penetration over 10 years (1995–2004) , 2007 .

[27]  N. Tandon,et al.  A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearings , 1999 .

[28]  Fengshou Gu,et al.  A Novel Fault Detection Method for Rolling Bearings Based on Non-Stationary Vibration Signature Analysis , 2019, Sensors.

[29]  Fred B. Oswald,et al.  Effect of Internal Clearance on Load Distribution and Life of Radially Loaded Ball and Roller Bearings , 2012 .