Modeling fuel preparation and stratified combustion in a gasoline direct injection engine

[1]  H. Ando,et al.  Development of Gasoline Direct Injection Engine , 1997 .

[2]  M. Metghalchi,et al.  Laminar burning velocity of propane-air mixtures at high temperature and pressure , 1980 .

[3]  Yong Liu,et al.  Modeling of NOx Emissions with Comparison to Exhaust Measurements for a Gas Fuel Converted Heavy-Duty Diesel Engine , 1996 .

[4]  S. Turns.  Introduction to Combustion , 1995, Aerothermodynamics and Jet Propulsion.

[5]  Peter J. O'Rourke,et al.  The TAB method for numerical calculation of spray droplet breakup , 1987 .

[6]  R. Reitz,et al.  Turbulence Modeling of Internal Combustion Engines Using RNG κ-ε Models , 1995 .

[7]  Rolf D. Reitz,et al.  Multidimensional Modeling of Spray Atomization and Air-Fuel Mixing in a Direct-Injection Spark-Ignition Engine , 1997 .

[8]  Rolf D. Reitz,et al.  Multidimensional modeling of engine combustion chamber surface temperatures , 1997 .

[9]  Rolf D. Reitz,et al.  Modeling Engine Spray/Wall Impingement , 1988 .

[10]  B. Hjertager,et al.  On mathematical modeling of turbulent combustion with special emphasis on soot formation and combustion , 1977 .

[11]  Rudolf Maly,et al.  A Fundamental Model for Flame Kernel Formation in S. I. Engines , 1992 .

[12]  Rolf D. Reitz,et al.  MODELING ATOMIZATION PROCESSES OF PRESSURE-SWIRL HOLLOW-CONE FUEL SPRAYS , 1997 .

[13]  J. Warnatz,et al.  Numerical Investigation of the Combustion Process in a Direct-Injection Stratified Charge Engine , 1996 .

[14]  Frediano V. Bracco,et al.  Comparisons of computed and measured premixed charge engine combustion , 1985 .

[15]  A. A. Amsden,et al.  KIVA-3V: A Block-Structured KIVA Program for Engines with Vertical or Canted Valves , 1997 .

[16]  Dennis N. Assanis,et al.  Optimizing Gaseous Fuel-Air Mixing in Direct Injection Engines Using an RNG Based k-ε Model , 1998 .

[17]  L. Wachters,et al.  The heat transfer from a hot wall to impinging water drops in the spheroidal state , 1966 .