A numerical study on the effects of EGR and spark timing to combustion characteristics and NOx emission of a GDI engine

ABSTRACT EGR is one of the most significant strategies for reducing especially nitrogen oxides (NOx) emissions from internal combustion engines. The thermal efficiency of spark ignition engines is lower than compression ignition engines because of its lower compression ratio. If the compression ratio is increased to obtain higher thermal efficiency, there may be a knocking tendency in spark ignition engines. EGR can be used in order to reduce NOx emissions and avoid knocking phenomena at higher compression ratios. In-cylinder temperature at the end of combustion is decreased and heat capacity of fresh charge is increased when EGR applied. Besides EGR, spark timing is another significant parameter for reducing exhaust emissions such as nitrogen oxides, and unburned hydrocarbon (UHC). In this study the effects of EGR and spark timing on spark ignition engine were investigated numerically. KIVA codes were used in order to model combustion process. The combustion process has been modeled for a single cylinder, four stroke and gasoline direct injection (GDI) spark ignition engine. The results showed that in-cylinder pressure and heat release rate decrease as EGR ratio increase. In-cylinder pressure increases with the advancing of spark timing. Advancing spark timing increases the heat release rate and in-cylinder temperature. The simulation results also showed that EGR reduced exhaust gas temperature and NOx emissions.

[1]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[2]  P. Heldt.  The gasoline engine , 1926 .

[3]  Hamit Solmaz,et al.  ESTIMATION OF NUMBER OF VEHICLES AND AMOUNT OF POLLUTANTS GENERATED BY VEHICLES IN TURKEY UNTIL 2030 , 2012 .

[4]  Alex C. Alkidas,et al.  Combustion advancements in gasoline engines , 2007 .

[5]  T. W. Forest,et al.  Effect of hydrogen addition on the performance of methane-fueled vehicles. Part I: effect on S.I. engine performance , 2001 .

[6]  Martin Wirth,et al.  Turbocharging the DI Gasoline Engine , 2000 .

[7]  Jeffrey Naber,et al.  Combustion characterization in an internal combustion engine with ethanol - Gasoline blended fuels varying compression ratios and ignition timing , 2009 .

[8]  Saiful Bari,et al.  A comparison between EGR and lean-burn strategies employed in a natural gas SI engine using a two-zone combustion model , 2009 .

[9]  Paulina S. Kuo.  Cylinder Pressure in a Spark-Ignition Engine: A Computational Model , 1996 .

[10]  Zunqing Zheng,et al.  Experimental Study on the Effects of EGR and Octane Number of PRF Fuel on Combustion and Emission Characteristics of HCCI Engines , 2005 .

[11]  S. Shuai,et al.  Optimization of gasoline hydrocarbon compositions for reducing exhaust emissions. , 2009, Journal of environmental sciences.

[12]  Bertrand Lecointe,et al.  Downsizing a Gasoline Engine Using Turbocharging with Direct Injection , 2003 .

[13]  Shawki Abouel-Seoud,et al.  Evaluation of Urban Bi-Fuel Vehicle Exhaust Emission During On-Road Test Facilities , 2012 .

[14]  Pierre Leduc,et al.  Downsizing of Gasoline Engine: an Efficient Way to Reduce CO2 Emissions , 2003 .

[15]  Hua Zhao,et al.  Gas Sampling Analysis of A Low-Temperature Compression Ignition Reaction Process in an Engine Fueled with Methanol and Gasoline , 2014 .

[16]  Bing Liu,et al.  Experimental investigation on performance and emissions of a spark-ignition engine fuelled with natural gas–hydrogen blends combined with EGR , 2009 .

[17]  Bing Liu,et al.  Cycle-by-cycle variations in a spark ignition engine fueled with natural gas–hydrogen blends combined with EGR , 2009 .

[18]  E. Galloni,et al.  Numerical analyses of EGR techniques in a turbocharged spark-ignition engine , 2012 .

[19]  Hamit Solmaz,et al.  A Comparison of Engine Performance and the Emission of Fusel Oil and Gasoline Mixtures at Different Ignition Timings , 2015 .

[20]  Jeffrey Naber,et al.  Estimation of double-Wiebe function parameters using least square method for burn durations of ethanol-gasoline blends in spark ignition engine over variable compression ratios and EGR levels , 2011 .

[21]  Christopher H. Onder,et al.  EGR control of pressure-wave supercharged IC engines , 2007 .

[22]  John Stokes,et al.  A Gasoline Engine Concept for Improved Fuel Economy -The Lean Boost System , 2000 .

[23]  Zhen Huang,et al.  HC and CO emissions of premixed low-temperature combustion fueled by blends of diesel and gasoline , 2012 .

[24]  Hua Zhao,et al.  Understanding the Effects of Recycled Burnt Gases on the Controlled Autoignition (CAI) Combustion in Four-Stroke Gasoline Engines , 2001 .

[25]  Hua Zhao.  Hcci and Cai Engines for the Automotive Industry , 2007 .

[26]  Zuo-hua Huang,et al.  Emission characteristics of a spark-ignition engine fuelled with gasoline-n-butanol blends in combination with EGR , 2012 .

[27]  Rui Chen,et al.  On the Mechanism of Controlled Auto Ignition , 2002 .

[28]  Ghazi A. Karim,et al.  An analytical examination of the effects of hydrogen addition on cyclic variations in homogeneously charged compression–ignition engines , 2000 .

[29]  H. Solmaz,et al.  Estimation of Amount of Pollutants Generated by Vehicles in Turkey Until 2030 , 2012 .

[30]  Zuo-hua Huang,et al.  Experimental study on combustion characteristics of a spark-ignition engine fueled with natural gas–hydrogen blends combining with EGR , 2009 .