EUV pattern defect detection sensitivity based on aerial image linewidth measurements

As the quality of EUV-wavelength mask inspection microscopes improves over time, the image properties and intensity profiles of reflected light can be evaluated in ever-greater detail. The SEMATECH Berkeley Actinic Inspection Tool (AIT) is one such microscope, featuring mask resolution values that match or exceed those available through lithographic printing in current photoresists. In order to evaluate the defect detection sensitivity of the AIT for dense line patterns on typical masks, the authors study the linewidth roughness (LWR) on two masks, as measured in the EUV images. They report the through-focus and pitch dependence of contrast, image log slope, linewidth, and LWR. The AIT currently reaches LWR 3σ values close to 9nm for 175nm half-pitch lines. This value is below 10% linewidth for nearly all lines routinely measured in the AIT. Evidence suggests that this lower level may arise from the mask’s inherent pattern roughness. While the sensitivity limit of the AIT has not yet been established, it ...

[1]  C. Mack Field Guide to Optical Lithography , 2006 .

[2]  Guojing Zhang,et al.  System-level line-edge roughness limits in extreme ultraviolet lithography , 2008 .

[3]  Tilmann Heil,et al.  EUV imaging: an aerial image study , 2004, SPIE Advanced Lithography.

[4]  Sungmin Huh,et al.  Mask defect verification using actinic inspection and defect mitigation technology , 2009, Advanced Lithography.

[5]  Iacopo Mochi,et al.  Benchmarking EUV mask inspection beyond 0.25 NA , 2008, Photomask Technology.

[6]  Kenneth A. Goldberg,et al.  Performance of actinic EUVL mask imaging using a zoneplate microscope , 2007, SPIE Photomask Technology.

[7]  Kenneth A. Goldberg,et al.  Actinic extreme ultraviolet mask inspection beyond 0.25numericalaperture , 2008 .

[8]  Sang-Gyun Woo,et al.  Analysis of process margin in EUV mask repair with nano-machining , 2008, Photomask Technology.

[9]  Kenneth A. Goldberg,et al.  Collecting EUV mask images through focus by wavelength tuning , 2009, Advanced Lithography.

[10]  Kenneth A. Goldberg,et al.  Improving the performance of the actinic inspection tool with an optimized alignment procedure , 2009, Advanced Lithography.

[11]  Kenneth A. Goldberg,et al.  Comparison of fast 3D simulation and actinic inspection for EUV masks with buried defects , 2009, Advanced Lithography.

[12]  John W. Bossung Projection Printing Characterization , 1977, Other Conferences.

[13]  John J. Biafore,et al.  Optical Lithography Modeling , 1997 .