Vibrations of probe used for the defect detection of helical heating tubes in a fast breeder reactor: Part 1. Experimental results by using mock-up

Abstract This paper deals with the vibration and the sensor signal noise of the eddy current testing (ECT) probe used for a defect detection of helical heating tubes in the fast breeder reactor “Monju”, developed in Japan. ECT probes are used for the detection of defects in a heating tube. The heating tube is composed of a helical tube and a straight tube because of their advantages of thermal efficiency and saving space. No vibrations of the ECT probe have been generated in usual straight heating tubes. However, vibrations of the ECT probe in the helical tube cause some noise and decrease the sensitivity of the ECT probe. The experiment was performed using a mock-up, and the noise characteristics of an ECT sensor mounted in an ECT probe were examined. The experimental results showed that the sensor signal noise during the insertion process of the ECT probe was higher than that of the return process, and vibrations of the insertion process had a certain emerging frequency. Attaching the long and flexible guide probe to the top of the ECT probe was an effective countermeasure against sensor signal noise.

[1]  T. Belytschko,et al.  Computational Methods for Transient Analysis , 1985 .

[2]  Hiroyuki Fukutomi,et al.  Inverse Problem Analyses with Noised Signals in Eddy Current Testing. , 2000 .

[3]  Yi Min Xie,et al.  AN ASSESSMENT OF TIME INTEGRATION SCHEMES FOR NON-LINEAR DYNAMIC EQUATIONS , 1996 .

[4]  Haoyu Huang,et al.  Development of an Arrayed Multi-coil Eddy Current Testing Probe without Less Sensitive Regions and its Application to Steam Generator Tube Inspection with Noise Source Outside , 2003 .

[5]  Hiroyuki Fukutomi,et al.  Numerical evaluation of correlation between crack size and eddy current testing signal by a very fast simulator , 1998 .

[6]  Declan Robinson.  Identification and sizing of defects in metallic pipes by remote field eddy current inspection , 1998 .

[7]  E. F. Kurtz,et al.  Matrix methods in elastomechanics , 1963 .

[8]  Atsuo Sueoka,et al.  TIME HISTORICAL RESPONSE ANALYSIS BY APPLYING THE TRANSFER INFLUENCE COEFFICIENT METHOD , 1997 .

[9]  Hideyuki Tamura,et al.  A Method of High Speed Structural Analysis Using a Personal Computer : Comparison with the Transfer Matrix Method , 1985 .

[10]  Baldev Raj,et al.  Development of In-service Inspection techniques for nuclear power plants in India , 1997 .

[11]  Gui Yun Tian,et al.  Reduction of lift-off effects for pulsed eddy current NDT , 2005 .

[12]  Y. Le Bihan,et al.  Lift-off and tilt effects on eddy current sensor measurements: a 3-D finite element study , 2002 .

[13]  M. Isobe.  High Sensitive Remote Field Eddy Current Testing by using Dual Exciting Coils , 1995 .

[14]  M. Crisfield,et al.  An energy conserving co-rotational procedure for non-linear dynamics with finite elements , 1996 .

[15]  J. M. S. Dubois,et al.  Pulsed Eddy Current Technology: Characterizing Material Loss with Gap and Lift-off Variations , 2001 .

[16]  Atsuo Sueoka,et al.  Vibrations of probe used for the defect detection of helical heating tubes in a fast breeder reactor. Part 2. Vibration analysis and numerical simulations , 2007 .