Investigation on the thermal performance of different lightweight roofing structures and its effect on space cooling load

The lightweight aluminum standing seam roofing system (LASRS) has been widely used as a building element in the construction of either commercial or governmental buildings, and has been proven to be an economic roofing system. However, little research has been conducted into its thermal performance and the effect of the absorptivity (colour) of its external surface on space cooling load in the hot humid area. This paper aims to investigate the thermal performance of the LASRS. A dynamic model is introduced for analyzing the transient heat transfer through the roofs, which was solved by the control volume finite-difference method employing an explicit scheme and validated by measured data. The simulation results show that the heat flux through the roofing system with a polyurethane insulation layer is smaller than that through the lightweight roof with glasswool insulation R1. The space cooling load reduction ratio for light painted envelop could reach about 9.3% compared with black painted one. The cooling load reduction ratio ranges from 1.3% to 9.3% for the roof structure R1 with various surface colour. Therefore, the space cooling load for air conditioning of the building can be considerably reduced (up to 20%) by employing a lightweight roof using polyurethane insulation with white painted surface colour.

[1]  M. Yazdanian,et al.  Measurement of the Exterior Convective Film Coefficient for Windows in Low-Rise Buildings , 1993 .

[2]  Vice President,et al.  AMERICAN SOCIETY OF HEATING, REFRIGERATION AND AIR CONDITIONING ENGINEERS INC. , 2007 .

[3]  Sami A. Al-Sanea.  Thermal performance of building roof elements , 2002 .

[4]  G. M. Zaki,et al.  Cooling load response for building walls comprising heat storing and thermal insulating layers , 1991 .

[5]  Søren Østergaard Jensen,et al.  Validation of building energy simulation programs: a methodology , 1995 .

[6]  Francis W.H. Yik,et al.  Cooling energy evaluation for high-rise residential buildings in Hong Kong , 2005 .

[7]  Meral Özel,et al.  Optimum location and distribution of insulation layers on building walls with various orientations , 2007 .

[8]  John Burnett,et al.  Simple approach to cooling load component calculation through PV walls , 2000 .

[9]  W. Beckman,et al.  Evaluation of hourly tilted surface radiation models , 1990 .

[10]  Edward Ng,et al.  Effect of envelope colour and thermal mass on indoor temperatures in hot humid climate , 2005 .

[11]  John Burnett,et al.  Building-integrated photovoltaics: effect on the cooling load component of building façades , 2001 .

[12]  Jeffrey D. Spitler,et al.  Cooling and heating load calculation manual , 1992 .

[13]  N. K. Bansal,et al.  Effect of exterior surface colour on the thermal performance of buildings , 1992 .

[14]  T M Chung Bsc MSc PhD CEng Mhkie Mcibse Mashrae,et al.  A Method to Estimate Direct and Diffuse Radiation in Hong Kong and its Accuracy , 1995 .

[15]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[16]  Emad Al-Regib,et al.  Transient heat transfer through insulated walls , 1995 .

[17]  M. F. Zedan,et al.  An efficient solution for heat transfer in composite walls with periodic ambient temperature and solar radiation , 1993 .

[18]  Y. Çengel.  Heat Transfer: A Practical Approach , 1997 .

[19]  A. A. El Damatty,et al.  Component testing and finite element modeling of standing seam roofs , 2003 .