Machining Characteristics of Al2O3/6061Al Composite using Rotary EDM with a Disklike Electrode

This work optimises the cutting of Al 2 O 3 /6061Al composite using rotary electro-discharging machining (EDM) with a disklike electrode by using Taguchi methodology. The Taguchi method is used to formulate the experimental layout, to analyse the effect of each EDM parameter on the machining characteristics, and to predict the optimal choice for each EDM parameter. Four observed values, MRR, EWR, REWR, and SR, are used to verify this optimisation of the machining technique. In addition, six independent parameters are chosen as variables in evaluating the Taguchi method and are categorised into two groups:1. Electrical parameters, e.g. polarity, peak current, pulse duration, and powder supply voltage.2. Non-electrical parameters, e.g. circumferential speed of electrode, reciprocating speed. The analysis of the Taguchi method reveals that, in general, the electrical group more significantly affects the machining characteristics than the non-electrical group. Also derived herein are semi-empirical equation that contain all of the machining characteristics. Experimental results are presented to illustrate the proposed approach.

[1]  M. Taya,et al.  EDM machinability of SiCw/Alcomposites , 1989 .

[2]  Mukund R. Patel,et al.  Theoretical models of the electrical discharge machining process. II. The anode erosion model , 1989 .

[3]  Akira Okada,et al.  Electrical Discharge Machining of Groove with a Rotating Disk Electrode , 1994 .

[4]  H. Hocheng,et al.  Preliminary study of material removal in electrical-discharge machining of SiC/Al , 1997 .

[5]  Mukund R. Patel,et al.  Theoretical models of the electrical discharge machining process. I. A simple cathode erosion model , 1989 .

[6]  Madhan Shridhar Phadke,et al.  Quality Engineering Using Robust Design , 1989 .

[7]  Y. Dai,et al.  An Examination of Wire Electrical Discharge Machining (WEDM) of Al2O3 Particulate Reinforced Aluminum Based Composites , 1996 .

[8]  M. Ramulu,et al.  EDM sinker cutting of a ceramic particulate composite, SiC-TiB sub 2 , 1988 .

[9]  D. M. R. Taplin,et al.  The turning of an Al/SiC metal-matrix composite , 1992 .

[10]  J. Monaghan,et al.  The drilling of an Al/SiC metal-matrix composite , 1992 .

[11]  Biing-Hwa Yan,et al.  Machinability of SiC particle reinforced aluminum alloy composite material. , 1993 .

[12]  G. K. Lal,et al.  Experimental investigations into electrical discharge machining with a rotating disk electrode , 1993 .

[13]  W. B. Lee,et al.  Un-conventional machining of composite materials , 1995 .

[14]  T. M. Yue,et al.  Pulsed Nd:YAG Laser Cutting of Al/Li/SiC Metal Matrix Composites , 1996 .