New equipment for testing steady and transient thermal performance of multilayered building envelope

Abstract Thermal properties of the different building envelopes, such as thermal transmittance in steady state, heat storage capacity and dynamic thermal responses, must be taken into account during the design phase of buildings. The evaluation and measurement of these parameters in multilayered samples are difficult because of the irregular morphology of the used materials and the difficulty in providing the well-controlled environment needed for the measurements. A new equipment has been designed to measure the thermal response and heat capacity of composite walls of different materials simulating real building envelopes. The equipment presented in this paper was used to test the improvement in the thermal response of a building envelope due to the incorporation of PCM. This study is focused on wood structural panels attached to a gypsum board, which is either impregnated or not with PCM. The four edges of the composite sample are properly insulated to ensure one-dimensional heat flow. The two faces of the sample are exposed to controlled environments heated and cooled by copper coils with thermo stated water supplied by water baths. The measured surface heat fluxes at both surfaces of the sample and temperature distribution in the sample provide accurate assessment to thermal mass and dynamic response of the composite wall, while the steady state measurements provide an accurate estimate of its effective thermal transmittance.