On optimum combining at the mobile

Optimum combining for diversity antennas at the mobile is discussed. Effectively, the aim is to add the wanted signal vectors in a maximum ratio sense, while interferers are weighted so that their resultant is in a permanent deep fade. Even if there are not enough degrees of freedom available to accomplish this fully, an optimum solution can still be found. Many interpretations from conventional array technology do not apply to the mobile communications case and the mechanism of optimum combining for array branch signals rather than discrete spatial signals is reviewed. Physical interpretation of the formulation is emphasized throughout. Problems with the adaptive algorithm and its implementation are also identified. Sample matrix inversion is shown to be a likely algorithm to apply in vehicular mobile communications receivers. A worst case example gives an idea of the required computation rates. >

[1]  B. Widrow,et al.  Adaptive antenna systems , 1967 .

[2]  W. White,et al.  Cascade preprocessors for adaptive antennas , 1976 .

[3]  I. Reed,et al.  Rapid Convergence Rate in Adaptive Arrays , 1974, IEEE Transactions on Aerospace and Electronic Systems.

[4]  S. Applebaum,et al.  Adaptive arrays , 1976 .

[5]  Yu-Shuan Yeh,et al.  Efficient Spectrum Utilization for Mobile Radio Systems Using Space Diversity , 1982, IEEE Trans. Commun..

[6]  B. Glance,et al.  Frequency-Selective Fading Effects in Digital Mobile Radio with Diversity Combining , 1983, IEEE Trans. Commun..

[7]  D. Boroson,et al.  Sample Size Considerations for Adaptive Arrays , 1980, IEEE Transactions on Aerospace and Electronic Systems.

[8]  J.H. Winters,et al.  Optimum combining in digital mobile radio with cochannel interference , 1984, IEEE Transactions on Vehicular Technology.

[9]  R.T. Compton,et al.  An adaptive array in a spread-spectrum communication system , 1978, Proceedings of the IEEE.