论文信息 - Experimental study of P&O MPPT control for wind PMSG turbine

Experimental study of P&O MPPT control for wind PMSG turbine

The objective of this article is to study experimentally optimizing of a PMSG wind turbine connected to a DC-DC converter (Boost) and a resistive load. For this, tests were conducted to determine the law of open loop control (power versus the duty cycle for different values of wind speed and load). The results showed that the power passes through a maximum point. In order to extract the maximum power, for different values of wind speeds and load, an MPPT control "Perturb and Observe" P & O has been implemented on a DSPACE 1104. The experimental results showed the performance of the method suggested.

Smail Zouggar | Mohamed Larbi Elhafyani | Badreddine Lahfaoui | Mohammed Seddik

[1] P.L. Chapman,et al. Comparison of Photovoltaic Array Maximum Power Point Tracking Techniques , 2007, IEEE Transactions on Energy Conversion.

[2] Saad Mekhilef,et al. A novel MPPT algorithm for load protection based on output sensing control , 2011, 2011 IEEE Ninth International Conference on Power Electronics and Drive Systems.

[3] Abdullah M. Noman,et al. Simulation and dSPACE hardware implementation of the MPPT techniques using buck boost converter , 2013, 2013 Africon.

[4] A. Rabhi,et al. A STAND-ALONE SYSTEM ENERGY HYBRID COMBINING WIND AND PHOTOVOLTAIC WITH VOLTAGE CONTROL « FEEDBACK LOOP VOLTAGE » , 2010 .

[5] Smail Zouggar,et al. Experimental modeling and control of a small wind PMSG turbine , 2014, 2014 International Renewable and Sustainable Energy Conference (IRSEC).

[6] Mohammed Ouassaid,et al. Control of a PMSG based wind energy generation system for power maximization and grid fault conditions , 2013 .

[7] Chih-Ming Hong,et al. Maximum power point tracking-based control algorithm for PMSG wind generation system without mechanical sensors , 2013 .