A High Accuracy 3.1V Voltage Limiter for Enabling High Performance RFID Sensor Applications

This paper presents a low power voltage limiter design that avoids possible damages in the analog front-end of a RFID sensor due to voltage surges whenever the tag gets close to the reader. The proposed voltage limiter design takes advantage of the implemented bandgap reference block in order to provide a highly accurate limiting voltage in spite of temperature variation and process dispersion. The measured limiting voltage is 3.1V while showing a low current consumption of 100nA when the reader and the tag are far away, so that the sensitivity of the tag is not impacted due to an undesired consumption in the voltage limiter. The circuit is implemented in a low cost 180nm CMOS technology.

[1]  Roc Berenguer,et al.  A passive UHF RFID pressure sensor tag with a 7.27 bit and 5.47pJ capacitive sensor interface , 2012, 2012 IEEE/MTT-S International Microwave Symposium Digest.

[2]  Roc Berenguer,et al.  A low power voltage limiter for a full passive UHF RFID sensor on a 0.35 μm CMOS process , 2012, Microelectron. J..

[3]  David del Rio,et al.  A CMOS Low Frequency Analog RFID Front-End for the IoT , 2018, 2018 Conference on Design of Circuits and Integrated Systems (DCIS).

[4]  Gerald Holweg,et al.  A Multifrequency Passive Sensing Tag With On-Chip Temperature Sensor and Off-Chip Sensor Interface Using EPC HF and UHF RFID Technology , 2011, IEEE Journal of Solid-State Circuits.

[5]  R. Berenguer,et al.  Low power voltage limiter design for a full passive UHF RFID sensor , 2011, 2011 IEEE 54th International Midwest Symposium on Circuits and Systems (MWSCAS).

[6]  Gerald Holweg,et al.  A 7.9μW remotely powered addressed sensor node using EPC HF and UHF RFID technology with −10.3dBm sensitivity , 2011, 2011 IEEE International Solid-State Circuits Conference.

[7]  Roc Berenguer,et al.  Full Passive UHF Tag With a Temperature Sensor Suitable for Human Body Temperature Monitoring , 2010, IEEE Transactions on Circuits and Systems II: Express Briefs.

[8]  R. Weigel,et al.  A multistandard HF/ UHF-RFID-tag with integrated sensor interface and localization capability , 2012, 2012 IEEE International Conference on RFID (RFID).

[9]  Catherine Dehollain,et al.  Design of a passive UHF RFID tag for capacitive sensor applications , 2013, Proceedings of the 2013 9th Conference on Ph.D. Research in Microelectronics and Electronics (PRIME).

[10]  Fan Zhang,et al.  A 9.2µA gen 2 compatible UHF RFID sensing tag with −12dBm Sensitivity and 1.25µVrms input-referred noise floor , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[11]  Jong-Wook Lee,et al.  A Battery-Assisted Passive EPC Gen-2 RFID Sensor Tag IC With Efficient Battery Power Management and RF Energy Harvesting , 2016, IEEE Transactions on Industrial Electronics.

[12]  Bo Gao,et al.  A System-on-Chip EPC Gen-2 Passive UHF RFID Tag With Embedded Temperature Sensor , 2010, IEEE Journal of Solid-State Circuits.

[13]  Amine Bermak,et al.  Correction to "A Sub- μ W Embedded CMOS Temperature Sensor for RFID Food Monitoring Application" [Jun 10 1246-1255] , 2010, IEEE J. Solid State Circuits.