Control of the Air Supply Subsystem in a PEMFC with Balance of Plant Simulation

This paper deals with the design of a control scheme for improving the air supply subsystem of a Proton Exchange Membrane Fuel Cell (PEMFC) with maximum power of 65 kW. The control scheme is evaluated in a plant simulator which incorporates the balance of plant (BOP) components and is built in the aspenONE ® platform. The aspenONE ® libraries and tools allows introducing the compressor map and sizing the heat exchangers used to conduct the reactants temperature to the operating value. The PEMFC model and an adaptive controller were programmed to create customized libraries used in the simulator. The structure of the plant control is as follows: the stoichiometric oxygen excess ratio is regulated by manipulating the compressor power, the equilibrium of the anode-cathode pressures is achieved by tracking the anode pressure with hydrogen flow manipulation; the oxygen and hydrogen temperatures are regulated in the heat exchangers, and the gas humidity control is obtained with a simplified model of the humidifier. The control scheme performance is evaluated for load changes, perturbations and parametric variations, introducing a growing current profile covering a large span of power, and a current profile derived from a standard driving speed cycle. The impact of the control scheme is advantageous, since the control objectives are accomplished and the PEMFC tolerates reasonably membrane damage that can produce active surface reduction. The simulation analysis aids to identify the safe Voltage-Current region, where the compressor works with mechanical stability.

[1]  Luis M. Fernández,et al.  PEM fuel cell modeling using system identification methods for urban transportation applications , 2011 .

[2]  Surajeet Mohanty,et al.  Control strategy for PEM fuel cell power plant , 2012, 2012 1st International Conference on Power and Energy in NERIST (ICPEN).

[3]  S B Silva,et al.  Sizing and Optimization of Hybrid Photovoltaic, Fuel Cell and Battery System , 2011, IEEE Latin America Transactions.

[4]  Alessandro Pisano,et al.  Observer-Based Air Excess Ratio Control of a PEM Fuel Cell System via High-Order Sliding Mode , 2015, IEEE Transactions on Industrial Electronics.

[5]  Farshid Zabihian,et al.  Macro Level Modeling of a Tubular Solid Oxide Fuel Cell , 2010 .

[6]  Sharmina Begum,et al.  An Experimental and Numerical Investigation of Fluidized Bed Gasification of Solid Waste , 2013 .

[7]  V. Aul,et al.  Error handling approach of a PEM fuel cell system by nonlinear model predictive control , 2015, 2015 23rd Mediterranean Conference on Control and Automation (MED).

[8]  Joachim Horn,et al.  Power efficient operation of a PEM fuel cell system using cathode pressure and excess ratio by nonlinear model predictive control , 2015, 2015 European Control Conference (ECC).

[9]  L. Menna,et al.  Energy efficiency of membrane-based fuel processors – PEM fuel cell systems , 2010 .

[10]  Vincentius Surya Kurnia Adi,et al.  Development of flexible designs for PVFC hybrid power systems , 2015 .

[11]  Zidong Wei,et al.  A Review of Water Management in Polymer Electrolyte Membrane Fuel Cells , 2009 .

[12]  Debashisha Jena,et al.  Modeling, simulation & optimal control of non-linear PEM fuel cell with disturbance input , 2015, 2015 International Conference on Innovations in Information, Embedded and Communication Systems (ICIIECS).

[13]  Guidong Liu,et al.  Adaptive control of the airflow of a PEM fuel cell system , 2008 .

[14]  L. Salemme,et al.  Calculation of the energy efficiency of fuel processor – PEM (proton exchange membrane) fuel cell systems from fuel elementar composition and heating value , 2013 .

[15]  Jose De Jesus Rubio,et al.  Experimental control of a fuel cell , 2015, IEEE Latin America Transactions.

[16]  Cédric Damour,et al.  Fault Tolerant Control Strategy applied to PEMFC water management , 2015 .

[17]  Michael C. Georgiadis,et al.  Modeling, simulation and experimental validation of a PEM fuel cell system , 2011, Comput. Chem. Eng..

[18]  Ya-Xiong Wang,et al.  Feedforward fuzzy-PID control for air flow regulation of PEM fuel cell system , 2015 .

[19]  Kodjo Agbossou,et al.  Optimization-based energy management strategy for a fuel cell/battery hybrid power system , 2016 .

[20]  Huicui Chen,et al.  Main factors affecting the lifetime of Proton Exchange Membrane fuel cells in vehicle applications: A review , 2014 .

[21]  Taehoon Hong,et al.  A Process for the Implementation of New Renewable Energy Systems in a Building by Considering Environmental and Economic Effect , 2015 .

[22]  Masoud Rokni,et al.  Dynamic characteristics of an automotive fuel cell system for transitory load changes , 2013 .

[23]  Michael C. Georgiadis,et al.  Modelling and explicit model predictive control for PEM fuel cell systems , 2012 .

[24]  Jianqiu Li,et al.  Development of a PEM Fuel Cell City Bus with a Hierarchical Control System , 2016 .

[25]  Mohammad. Rasul,et al.  Performance analysis of an integrated fixed bed gasifier model for different biomass feedstocks , 2013 .

[26]  Wei Wu,et al.  Design, Optimization and Energetic Efficiency of Producing Hydrogen-Rich Gas from Biomass Steam Gasification , 2014 .

[27]  Hongye Su,et al.  Feedback linearization control of the air supply system of PEM fuel cells , 2015, 2015 10th Asian Control Conference (ASCC).

[28]  Luis M. Fernández,et al.  Control strategies for high-power electric vehicles powered by hydrogen fuel cell, battery and supercapacitor , 2013, Expert Syst. Appl..

[29]  V. R. Kavya,et al.  Steady state analysis and control of PEM fuel cell power plant , 2013, 2013 International Conference on Control Communication and Computing (ICCC).

[30]  Anna G. Stefanopoulou,et al.  Modeling and control for PEM fuel cell stack system , 2002, Proceedings of the 2002 American Control Conference (IEEE Cat. No.CH37301).

[31]  David Zumoffen,et al.  Adaptive predictive robust control for fuel cells hybrid vehicles , 2010, 2010 IEEE Vehicle Power and Propulsion Conference.

[32]  Yong Tang,et al.  Experimental investigation on the dynamic performance of a hybrid PEM fuel cell/battery system for lightweight electric vehicle application , 2011 .

[33]  Achim Kienle,et al.  Analysis of the Coupling Behavior of PEM Fuel Cells and DC-DC Converters , 2009 .

[34]  Michela Longo,et al.  Integration and optimization of renewables and storages for rural electrification , 2016 .

[35]  武彦 福島.  持続可能性(Sustainability)の要件 , 2006 .

[36]  David Zumoffen,et al.  Energy management strategy based on receding horizon for a power hybrid system , 2015 .

[37]  Carlos Andrés Ramos-Paja,et al.  Asymmetrical Interleaved DC/DC Switching Converters for Photovoltaic and Fuel Cell Applications—Part 1: Circuit Generation, Analysis and Design , 2012 .

[38]  Jianqiu Li,et al.  Model-based fuel pressure regulation algorithm for a hydrogen-injected PEM fuel cell engine , 2015 .

[39]  S. Odocio Almo Torres,et al.  Control Strategy for Balance of Plant in Solid Oxide Fuel Cell , 2013, IEEE Latin America Transactions.

[40]  Philipp Nadel,et al.  Control Of Fuel Cell Power Systems Principles Modeling Analysis And Feedback Design , 2016 .

[41]  T. Azib.  Contribution à l'étude d'électro-générateurs à pile à combustible : conceptions d'architectures et de leurs commandes , 2010 .

[42]  Kuei-Hsiang Chao,et al.  A Low-Cost High-Performance Interleaved Inductor-Coupled Boost Converter for Fuel Cells , 2016 .

[43]  Gholamreza Karimi,et al.  DYNAMIC MODELING, OPTIMIZATION AND CONTROL OF POWER DENSITY IN A PEM FUEL CELL , 2012 .

[44]  Mohammad. Rasul,et al.  Pyrolysis of Municipal Green Waste: A Modelling, Simulation and Experimental Analysis , 2015 .