Microstructure and property of sub-micro WC-10 %Co particulate reinforced Cu matrix composites prepared by selective laser sintering

[1]  J. Fuh,et al.  Microstructural evolution in direct laser sintering of Cu‐based metal powder , 2005 .

[2]  J. Ågren,et al.  Sintering shrinkage of WC–Co materials with bimodal grain size distributions , 2005 .

[3]  R. Roy,et al.  Comparison between microwave and conventional sintering of WC/Co composites , 2005 .

[4]  Abdolreza Simchi,et al.  Densification and microstructural evaluation during laser sintering of M2 high speed steel powder , 2004 .

[5]  L. Froyen,et al.  Selective laser melting of iron-based powder , 2004 .

[6]  T. Childs,et al.  Laser sintering (SLS) of hard metal powders for abrasion resistant coatings , 2004 .

[7]  Abdolreza Simchi,et al.  On the development of direct metal laser sintering for rapid tooling , 2003 .

[8]  Abdolreza Simchi,et al.  Effects of laser sintering processing parameters on the microstructure and densification of iron powder , 2003 .

[9]  Han Tong Loh,et al.  Direct laser sintering of a copper-based alloy for creating three-dimensional metal parts , 2003 .

[10]  Jerry Y. H. Fuh,et al.  Development and characterisation of direct laser sintering Cu-based metal powder , 2003 .

[11]  Tahar Laoui,et al.  Selective laser sintering of single‐ and two‐component metal powders , 2003 .

[12]  Li Lu,et al.  Direct metal laser sintering for rapid tooling: processing and characterisation of EOS parts , 2001 .

[13]  Didier Bouvard,et al.  Phenomenological analysis of densification kinetics during sintering : application to WC-Co mixture , 2000 .

[14]  J. Ågren,et al.  W content in Co binder during sintering of WC–Co , 1998 .

[15]  David L. Bourell,et al.  Direct laser freeform fabrication of high performance metal components , 1998 .